Is LEED Online mind-numbingly slow today for anyone else? Or is it just me? I may give up and try again tomorrow. Frustrating as I was hoping to submit a final review today. :(

Hey, all. Two questions:

-How do we communicate to you LEED User content that needs to be pulled through to BIT-user pages? Are you all going to assess each BP page for potential articles/topics that will be linked?

-Regarding the forums- is there a way to notify program staff when a forum has an unanswered question? Hoping to... Read more

Hello Sustainable Construction Leaders,

We’re happy to see the first round of registrations rolling in! If you haven’t yet, make sure to register here. And if you have any friends not currently in our Member Directory that you’d like to see at the Summit, encourage them to reach out to me (candace@buildinggreen.com). We’ll get them set... Read more

As BuildingGreen’s Products & Materials Specialist, Brent excels at deep, unbiased, and nuanced technical research on the health and environmental impacts of green building products and materials. Some areas of focus include:

product and material constituents, including their risks

product certifications

third-... Read more

Welcome to the quiz portion of What Makes the Building Envelope Green? BuildingGreen’s Guide to Thermal & Moisture Protection Products.

Learning Objectives
Upon completing this course, participants will be able to:


 

1. Describe attributes of the greenest building envelope products.
2. Explain how to... Read more

Peer Networks Application for Peer Network Membership Sustainable Design Leaders

The Sustainable Design Leaders peer group brings together the most committed sustainable design directors from leading architecture firms throughout the U.S. and Canada. We invite you to apply for membership.
We look for the... Read more

Hello Everyone,

Here are some of the Show & Tell presentations from the 2019 SDL Winter Summit, enjoy!!

Best,

RoseAnn

Our high performance consulting team is frustrated by project teams that regularly fall back on outdated rules of thumb in their system and equipment sizing. 

What challenges do you face in your work flow to limit oversizing and promote right-sizing?

By the way, Roger Chang, our literature search on the subject turned up an eleven... Read more

Mary Ann Lazarus

Hello, fellow SDLs, 

I wanted to share an opportunity for you - or those in your network - to join a passionate team of architects and designers based in Anchorage, Alaska. I'm told that you'd be asked to join the full team in Anchorage a few times a year for team building events but otherwise you can WFW (work from wherever!).

I... Read more

Wood decking requires potentially hazardous preservatives and stains, and plastic waste is a significant environmental problem.

BuildingGreen-Approved Decking

Composite decking approved by BuildingGreen has at least 50% total recycled content. For plastic decking, post-consumer content has to be greater than 50%.

Health and... Read more

Good evening,

I am looking for suggestions to replace"wood" siding at the 25-year-old Lyle Center for Regenerative Studies and as always there is no solution that does it all. There seem to be three main options: wood, composition siding, or fiber cement siding. I am looking for something with low embodied carbon, little maintenance,... Read more

Folks -anyone know if the 179D Commercial Buildings Energy Efficiency Tax Credit will be renewed for this year? The DOE website only references renewal on Jan 1, 2017... I am not holding my breath, but curious if anyone else has heard one way or the other. Thanks!

Hi All,

It's been a great week to get the message out about the importance of sustainability in our work, and this group brings such a rich and nuanced perspective to the table. I'm asking, if you published something for earth day this week for external consumption, could you share that here? I'm curious to see if there are common themes... Read more

Hello!

I'm curious what other firms like to use to run site-specific sun path and wind path analysises that is relatively intuitive to use and generates good graphics. We have used the climate consultant software for wind roses which is free and simple. We've also used sefaira but we're hoping to crowd source more resources. We purchased... Read more

Hi all,

We are looking to study Passive House on a couple small multifamily projects. Our understanding is that WUFI Passive only integrates with SketchUp at this time. Our BIM manager has been trying to find an example of a firm that works in Revit and uses WUFI Passive, to point him in the right direction on workflow. I offered to ask... Read more

Hello. Has anyone tackled "tracking emissions from all company-purchased cloud computing" yet? This is in the best category for CC 2.0 and wanted to ask.

How "deep" did you go? 

This was an interesting read, but still left me a little confused about how far I need to go and even what questions to ask:   

https://medium.com/... Read more

Embodied carbon in products and existing buildings. What does LCA tell us about renovation vs. new construction and material choices?

Guiding Questions: 

What easy ways are there to communicate about embodied carbon? Are there easy ways to calculate it?  What do I need to know about LCA? Are there any found patterns of when it... Read more