THIS WEBINAR PURCHASE AND REGISTRATION IS CLOSED.

In simpler times, our buildings were made primarily from local, natural substances like stone, wood, straw, and clay.

But lifestyles have changed dramatically since these were... Read more

Want to make sure those in Portland are aware of a couple of LF18 Ramp-Up Events happening on April 10th. 

Introduction to the Living Building Challenge (presented by Kathleen Smith)
https://living-future.org/events/introduction-to-the-living-building-challenge/

Incentivizing Living Buildings in Portland 
https://... Read more

Hi! Just saw this White House press release stating that federal suppliers will need to report on scope 1 & 2, and relevant scope 3 emissions and climate-related financial risks as well as set science-based emission reduction targets. The cutoff for disclosure requirements is $50m in federal contracts. Curious whether this affects any... Read more

A new article addressing whether PFAS finishes on upholstery fabric actually work (Spoiler alert - they don't) has been published and can be found here:

https://journals.sagepub.com/doi/10.1177/24723444231159856

This is authored by the fine folks at Green Science Policy, Arlene Blum's group that is the source of the Six Classes of... Read more

Welcome to the quiz portion of Innovative Products and Technology from the Greenbuild Expo

Learning Objectives
Upon completing this course, participants will be able to:


1. Direct attention to green building products and technologies that show exceptional potential, from a whole-systems perspective, to bring the... Read more

Hello Everyone!

Wondering if anyone has expertise in Algae Photobioreactor facades? Here is a product: https://cellparc.com/

My basic understanding is that they produce heat and biogas (as well as providing shade and some thermal value.)  However, I am not clear on the GHG balance benefit, so to speak.  I cannot determine if the... Read more

Dear SDL'ers

After many months of soul searching about my role as a sustainability leader and how to have the most positive environmental impact, I have decided to take a leave from practice to pursue further studies this September. I will be undertaking a two year Master’s degree at the Institute for Resources, Environment and... Read more

We just wrapped up an awesome Winter Summit at Gulf State Park in Alabama. I'll be posting flip chart pages and notes here--we can use this forum to continue the conversations. 

Apologies for the flurry of emails, but it seems best to start separate threads for each topic. If you'd rather limit the flow, you can switch to daily digest... Read more

Hello all,

I have a quick question for you. While Energy Star appliances are a no-brainer for projects, I don't see a hard requirement to select Energy Star appliances in the energy prereq/credit. There are references in the water section for water using appliances like ice machines, dishwashers, clothes washers, etc., but no related... Read more

Hello friends,

We are looking for recommendations for solar photovoltaic consultants to support one of our projects. We have used SEI in the past, but would like to develop a deeper bench and approach it from another angle. We aren’t too concerned about the consultant’s location, but are looking for someone that is on top of the current... Read more

I've written waste and recycling policies many a time before for both construciton and operations... but in a volunteer committee application this morning, the maintenance team got bogged down on "how do we collect recycling without plastic bags" question. I told them there's not any kind of plastic bag that I'm aware of which can be thrown... Read more

Hi, I've been following the copper piping discussion and am wondering if copper piping has been a problem in greywater systems.    We've used Aquatherm to some extent in greywater treatment.

Colleagues

It has been my great pleasure to serve the AIA's COTE Top Ten review process, both as a main juror and, most recently, as one of the technical review team.  I have specifically reviewed the Discovery and Energy measures for the past few years.  I will be serving again on the 2021 team.  The AIA has already received many more... Read more

CEUs are available for reading all the building-envelope product guides and primer. Click here to learn more and take the quiz.

Vapor retarders are meant to protect our building assemblies from getting wet, but they can also slow drying, contributing to mold and structural degradation.

BuildingGreen-Approved Vapor Retarders