BuildingGreen Report

Firm-wide Group

Forum topic

Hello,

We are in the very early planning phase of a k-8 public school project to be designed and built in an economically challenged urban location with very limited site options. The project is not LEEDv4 registered yet.  We are at feasibility and costing the soil remediation, needless to say that we would really hope there would be... Read more

Forum topic

Hi All,

I meant to put this is in Green Gurus and put it in SAL instead.  Rookie mistake.

After this long winter, who is up for some fierce creativity and friendly competition internal to your company or between Green Gurus?  What do you think of a location agnostic, virtual, Sustainability Scavenger Hunt from Earth Day to Mother'... Read more

Campus-wide Group

Forum topic

Hi all - Reflecting on the COTE Top Ten Awards and Lloyd Alter's recent article  https://www.treehugger.com/green-architecture/keep-aiacotes-its-time-scrap-aia-awards.html, I am curious how many local/state AIA awards programs have incorporated sustainability reporting metrics as a requirement for all awards submissions, not just for categories... Read more

Forum topic

Hi All - I wanted to share out the All For Reuse initiative below by two peers in the sustainable materials management network. I know some SDL have already done much research on this from quite a few angles, and those with LBC experience probably even moreso in practice. 

Frances Yang (Arup) and Andrew Ellsworth (Doors Unhinged) have... Read more

Forum topic

For a number of years a colleague and I have been teaching a course about sustainability and water in architecture at the University of Pennsylvania's architectural school (PennDesign).  This year we're hoping to bring a few new opinions to the table for at the same time as we broaden the discussion.  Because the class will be virtual again... Read more

Forum topic

Hi everyone - we have a new higher ed client who is committed to sustainability but not very knowledgeable about current topics such as carbon (both embodied and operational) or the electrification of buildings.  I need to educate them and would like to start with some easily-digestible background reading.  But as we all know, we're a bit dorky... Read more

Forum topic

Dear all,

Greetings. I'm presenting virtually to an audience of architecture and engineering faculty in India on the topic 'Introduction to Climate Change and Adaptive Architecture.' What is expected of the presentation is a broad overview of how climate change affects the built environment, challenges faced and some coping mechanisms. I... Read more

Product Guide

Board insulation has good thermal performance ranging from about R-4 to R-8 and is used as an integral part of a building envelope’s continuous insulation system.

Because board insulation is used on the building exterior, it is not always subject to the same material health and emissions requirements as batt insulation used inside the... Read more

Forum topic

The position for my replacement has been posted. Please share within your networks. Thanks!

http://www.fxcollaborative.com/profile/9/careers/

Forum topic

What thoughts do you have? What have others said that you feel we want to capture?

The Vision Vacuum: What’s driving environmental and social progress in architecture today? What should be driving it, and where should we be going?

Campus-wide Group

Basic page

Peer Networks SDL Green Gurus Member List Webinars Calendar Resources Help Forum Shared files About

Portal

The current Stantec/BuildingGreen featured topic is Resilient Design. Read on to learn the essentials, and then dive deep to earn CEUS.

Also see the Material Health featured topic, and also a survey of topics trending in Stantec’s regions.... Read more

Forum topic

On a large sports project, we worked with the structural engineer to spec low carbon / high SCM concrete mixes. Much of the floor area will be sealed and polished concrete, and a concrete sub is pushing back on the SCMs saying they should not be above 20% (with a preference for 0%) for the polish to finish properly, per the manufacturer. Anyone... Read more

Reports, Courses, Study Guides, Live Webinars

THIS WEBINAR PURCHASE AND REGISTRATION IS CLOSED.

Forum topic

Has anyone completed an LCA for an engineering structures lab, particularly one that has a strong wall and strong floor?