Hey Gurus. Might anyone have experience, or thoughts, with regard to establishing an energy use baseline for a new advanced manufacturing facility we are working on for a regional technical community college? This type of academic facility is so relatively new, the program doesn't fall into the typical "College/University" building type from ... Read more

Discarded tires are an environmental disaster, and finding a beneficial use for them is a high priority.

BuildingGreen does not approve any flooring product that is made with tire-derived rubber, though some products may be appropriate for exterior use.

Hi All,

I want to share this report, released today, that I and some other folks on Green Gurus have been working on.  The report dispels the myth that Zero Energy Buildings cost more (specifically in Massachusetts) and it goes further, making the case that Zero Energy Buildings are actually great investments.  Take a look, tell us what... Read more

A question for you, all input appreciated: What are some metrics and data points you all use to report out to your staff and leadership? I'm starting on higher-level analysis of our projects' performance by typology and through other lenses, and I wonder if you have found metrics or reporting points that are particularly impactful in your... Read more

He just posted the following on the Building Performance Knowledge Community forum:

Does anyone have a recommendation for software that is easy to use and relatively inexpensive for doing energy performance analysis at the schematic design (or before) phase?  We are looking for a tool that gives good quantitative comparisons for... Read more

We think fresh water supplies are endless, but this idealistic vision is clouded by the smoke of countless forest fires in the U.S. West and elsewhere. Instead of endless bounty, climate change is bringing us catastrophic droughts and flooding that now dominate the headlines and threaten entire regions.

This report covers innovative... Read more

Pint-flush and non-water urinals can save tens of thousands of gallons of potable water per year. A single non-water-using urinal can save more than 10,000 gallons of water per year compared with the U.S. EPA standard of 1.0 gallon per flush (gpf).

When older 3.0 gpf urinals are replaced, the savings can be as great as 50,000 gallons... Read more

Welcome to the quiz portion of Making Your Own Electricity: Onsite Photovoltaic Systems.

Learning Objectives
Upon completing this course, participants will be able to:


1. Explain the difference between crystalline and thin-film photovoltaic technologies, and the uses of each.
2. Describe the ways in which PV... Read more

Hi everyone, 

Thank you so much to the SDL members who attended the Summer 2023 Summit! We had an amazing time with you there. A big thanks as well to the attendees who shared 5-minute presentations during the summit.

Below are some of the slides for the presentations. Please note that we have permission from all of these... Read more

Can furniture be hazardous? You bet it can…

From flame retardants in foam cushions to unnecessary stain and dirt repellents on upholstery materials, everyday... Read more

Hi all,

I wanted to reach out to fellow MEP energy modeling teams to assess everyone's experience with the new PCI calculation methodology in 2016. It was a substantial change in how we show savings on projects. Big changes can often come with un-intended consequences. I'm all for pushing to higher efficiency - just want to make sure we... Read more

Sustainable Design Leaders in NYC

New York City has been discussing implementing PACE Financing for years but has not taken action. Over 48 municipalities in New York State have PACE financing for Commercial (including multi-family) properties, it's time NYC does as well. I recently learned from colleagues in the City that all of the... Read more

We are working on a large healthcare project in Minnesota.  We're setting sustainability goals a bit late - no certification, but targets with accountability.  I'm working to determine recycled steel content (for structural steel and rebar), and I've gotten a bit of push-back on recycled content based on being in the region of the Iron Range... Read more

Hi All:  We are in the design phase for a 5,700 SF project in NH. The team is taking care to drive down embodied carbon where possible. It will be NZE.

A1-A3 emissions are coming in at 67.15 kgCO2e/sf, of which 11.97 kgCO2e/sf is a hot spot attributed to permeable paving and concrete pavers (a little skewed, since lot and patio sizes... Read more

There are a number of SDL and other peer network folks talking about a potential casual meet up in association with Living Future 24 (next week in ATL).

In the interest of Julie McCoy-ing this thing into being ... 

Who: All y'all ... any Peer Network folks who are in town for LF24 (or local to ATL). 

Why: Connecting is... Read more

Hi All,

I wanted to pass on a few cool things we have going on at Built Environment Plus (formerly USGBC MA)  I really am conscious of not spamming you often and reserve posts for some of our most exciting happenings.

August 5, Building Tech Forum/MaterialsCAN: Getting to Zero with Embodied Carbon. Featuring 13 5-minute... Read more

Hi all,

I've tried a couple of different search terms for the forum but haven't been able to find any past conversations on electrochromic glazing yet (which makes me suspect I might be missing something...). We have a potential opportunity to use it in a vertical curtain wall application with a client that is very interested in the... Read more

Hi everyone,

Just a reminder to please fill out the SCL 2024 Events Attendance Poll by the end of next Monday, December 18th. Thank you so much to those who have filled it out already! :) 

-Amanda