Can furniture be hazardous? You bet it can…

From flame retardants in foam cushions to unnecessary stain and dirt repellents on upholstery materials, everyday... Read more

Hi All,

I am looking for a lifecycle analysis consultant to work on a feasibility study in New York. They should have capacity to analyze and compare various architectural, structural and mechanical components for environmental impacts, primarily GHG emissions. Any recommendations are greatly appreciated.

_Ilana

Hi folks,

A press release about this just showed up--most of what they're including in their "Clean Construction Declaration" involves reducing embodied carbon in materials, but they're also calling out construction equipment:

"Procure and, when possible, use only zero emission construction machinery from 2025 and require zero... Read more

I have been asked to recommend folks to join the AIA’s Framework for Design Excellence.  The AIA Framework for Design Excellence is basically the top ten toolkit, that has been rebranded by the AIA and is forming the backbone of much of the policy that the AIA is currently setting.

From the AIA's website:

Good morning. If you're worried  like I am by today's new IPCC Report and would like some helpful explanation I recommend reading climate scientist Zeke Hausfather's lengthy Twitter feed summarizing key aspects with graphics. It's here https://twitter.com/hausfath/status/1424642708291821569?s=21

of course we need to see this as an even... Read more

Composting toilets convert human waste into nutrient-rich fertilizer for nonfood plants, rather than mixing the waste with potable water and flushing it down the drain. They can also save infrastructure costs and minimize the burden on wastewater systems.

They’re not for every project, but they do warrant consideration. Composting... Read more

Welcome to the quiz portion of The BuildingGreen Guide to Insulation!

Learning Objectives
Upon completing this course, participants will be able to:


1. Discuss how insulation works to increase the energy efficiency and environmental sustainability of buildings; 
2. Explain why certain materials make more sense than... Read more

Hello friends. On a current school project, an abuse resistant wall covering has been proposed as an alternative to our typical MDF wainscot. The proposed product has been used successfully in healthcare, and switching to it will save the project almost $1million, which is no small amount when the project is over budget and 7-figure cost... Read more

Please see the following invite from Professor Alexandra Rempel at the University of Oregon to participate a 15-20 minute phone/Zoom interview and share your experience and/or perceptions on the problems, challenges, and barriers to incorporating into your projects.

This effort is part of an NSF research grant that I am involved in and... Read more

For those of you that attended Greenbuild this year you may have heard about the Legacy project taken on by the USGBCMA Chapter. The winning project was The Green Building Tech Club at Madison Park Technical Vocational High School. The USGBCMA Chapter recently reached out to me and asked if Structure Tone would take on an intern this summer,... Read more

Hi - we're working with the University of California Office of the President to put together low-carbon case studies. The two types we are looking for now include 1) a low-carbon TI (not a full building gut/renovation), and 2) any that involve the circular economy (in this case not just building reuse but product reuse) which could include... Read more

All,

I'm sure a few of you attended our recent  webinar on the LEED v4.1 LCA webinar. In case you missed it, the recording is posted. We were stunned by the amount of engagement from the audience; we allotted 30 minutes for questions and I think it went even longer. The webinar recording should be a great starting point for anyone... Read more

My company is looking for ways to introduce and train employees on jobsite recycling and composting. There is definitely a culture shift that needs to change in order for it to happen, but we are looking for any success stories to help us on our journey.

1) Has anyone been successful in setting up recycling/composting programs for... Read more

Does anyone know about temporary flushout equipment that could be used to augment a building's systems to get additional CFM of OA during construction?  For our non-laboratory type projects the flushout period ends up being too long, especially in either humid summers or frigid winters (Pennsylvania).

Hoping that some of you on either... Read more

Hi - Posting on behalf of Pete Munoz at Biohabitats

Biohabitats is hiring a proposal coordinator in Portland. Please spread the word. Thanks!

PROPOSAL COORDINATOR

Cascadia Bioregion Portland, Oregon is the preferred location, but will consider Denver, Colorado or  Santa Fe, New Mexico  

Years of Experience: 5+ years... Read more

Kelly provides administrative support to BuildingGreen projects, including major contracts as well as event planning, and logistics coordination for BuildingGreen’s network of sustainable design leaders. Among her projects, Kelly coordinated a large tri-state regional economic development project focused on the green goods and services industry... Read more