Our building scientist has been using Insight 360 to model daylight and document it for LEED certifications.  However, it appears that Autodesk is no longer fully supporting the tool and may eventually stop all together.  (we have not been able to run simulations for weeks due to a change to how "cloud credits" work on their end that they... Read more

A question for you, all input appreciated: What are some metrics and data points you all use to report out to your staff and leadership? I'm starting on higher-level analysis of our projects' performance by typology and through other lenses, and I wonder if you have found metrics or reporting points that are particularly impactful in your... Read more

Wondering if anyone has a slide presentation on the Framework for Design Excellence that they would be willing to share (to present to students). Rather than defining my request as lazy I'd like to offer up the qualification of efficiency.  

Welcome to the quiz portion of The Four Core Issues to Tackle for Resilient Design (And the Programs That Can Help).

Learning Objectives
Upon completing this course, participants will be able to:


1. Use site-specific hazard analysis to evaluate a project’s resiliency demands.
2. Use climate change data to... Read more

I received the following email from Naajia at Southface.  I'll be out of town until November 8, but I'll see if there's time for me to address at least the second part before I leave:

A question regarding the BIT-User Forum was brought to my attention by a participant. Apparently when you are posting a question and you pick your location... Read more

Hello all, 

Many of you have been asking about the CC reporting template for 2023 projects. It is still in-progress, but we can promise a huge upgrade from the past couple of years. In particular, the new template is designed for ongoing project tracking over the course of the year (rather than purely documentaion after the fact).  ... Read more

Welcome to the quiz portion of Is Wood Construction Green? A Look at the Issues.

Learning Objectives
Upon completing this course, participants will be able to:


1.  Determine what distinguishes wood products sourced from Forest Stewardship Council-certified forests, and why these products improve the environmental impact of... Read more

For a number of years a colleague and I have been teaching a course about sustainability and water in architecture at the University of Pennsylvania's architectural school (PennDesign).  This year we're hoping to bring a few new opinions to the table for at the same time as we broaden the discussion.  Because the class will be virtual again... Read more

Hi folks,

Here's the next Peer Networks private webinar. As usual, it will be recorded and shared in the network if you can't make it in person:

Thursday, July 18, 2pm EDT (11am PDT)

The Center for Active Design (CfAD), operator of the Fitwel Certification System, recently launched Fitwel v2.1, which advances a vision where... Read more

Wood decking requires potentially hazardous preservatives and stains, and plastic waste is a significant environmental problem.

BuildingGreen-Approved Decking

Composite decking approved by BuildingGreen has at least 50% total recycled content. For plastic decking, post-consumer content has to be greater than 50%.

Health and... Read more

Has anyone here performed circadian lighting studies for WELL using rhino/grasshopper (Lark Spectral Lighting)? 

It seems that Lark can only simulate circadian metrics for daylighting, and NOT electric lighting.  Can anyone shed some light on this?  pun intended :)

Are there any other tools out there that would enable us to... Read more

Hello SD Leaders!

Two weeks ago a group of us gathered for the Winter 2020 Sustainable Design Leaders Summit. Those of us from BuildingGreen that were on site, greatly appreciated everyone's time and energy. It's always a pleasure to work along side you all!

Here is the summit report!

Reminder: We are giving a priority look... Read more

Lake|Flato is growing our design performance team!  If you know any great applicants for our new design technologist position, please send them our way:

Design Technologist in San Antonio.pdf (lakeflato.com)

There has been a lot of discussion re antimicrobials in this group, so here is a pre-release of this month's article on the topic. It's not an extensive feature, but I hope you find it informative.

Brent

Hi all,

All members of the WA Building Code Council received an email from Tim Attebery of the Washington State AGC and I'm trying to make sense of the role of the AGC and whether it is representing the consensus option of general contractors in Washington or not. The letter is very much against the energy code advancement, which... Read more

Is your team working on a LEED v4 or WELL project? 

Finding products for these projects is daunting, and even when you find products you believe will meet the requirements, you have to know exactly... Read more