Hi All,

I want to share this report, released today, that I and some other folks on Green Gurus have been working on.  The report dispels the myth that Zero Energy Buildings cost more (specifically in Massachusetts) and it goes further, making the case that Zero Energy Buildings are actually great investments.  Take a look, tell us what... Read more

Hello SDL Peers,

We are currently in the process of expanding our firmwide carbon reporting (and goal setting). I am looking to see if anyone has some "best practices" or examples of their own firm's journey to carbon neutrality. Any info or tips are welcome!

Thx, JP

Hello SCL peeps, 

Thank you to all the people who filled out our 2021 event survey. Your feedback did help us narrow down the options, but it was still inconclusive about whether there’s enough interest in doing an SCL-only Summit. 

To stay on schedule with our planning (and to make sure the event will pencil out financially), we... Read more

Discarded tires are an environmental disaster, and finding a beneficial use for them is a high priority.

BuildingGreen does not approve any flooring product that is made with tire-derived rubber, though some products may be appropriate for exterior use.

This webcast was pre-approved for 1 AIA LU|HSW and 1 GBCI CE hour.

Please complete the survey questions to confirm your attendance and receive your CEUs.

By providing your credential numbers in your profile, you will enable us to automatically report these CEUs to these organizations. Please check your profile to be sure your... Read more

Pint-flush and non-water urinals can save tens of thousands of gallons of potable water per year. A single non-water-using urinal can save more than 10,000 gallons of water per year compared with the U.S. EPA standard of 1.0 gallon per flush (gpf).

When older 3.0 gpf urinals are replaced, the savings can be as great as 50,000 gallons... Read more

Welcome to the quiz portion of Making Your Own Electricity: Onsite Photovoltaic Systems.

Learning Objectives
Upon completing this course, participants will be able to:


1. Explain the difference between crystalline and thin-film photovoltaic technologies, and the uses of each.
2. Describe the ways in which PV... Read more

He just posted the following on the Building Performance Knowledge Community forum:

Does anyone have a recommendation for software that is easy to use and relatively inexpensive for doing energy performance analysis at the schematic design (or before) phase?  We are looking for a tool that gives good quantitative comparisons for... Read more

Team,

See this paper regarding outside air vs. filtration.

https://www.sciencedirect.com/science/article/pii/S0360132313002515

MERV-13 is a good way to get most benefits without a huge cost.

Best,
Luke Leung

Hello all,

I am reaching out to this community as SMMA has a job opening for a Sustainable Design Analyst (like many of you recently posting job openings on this forum).

Here is the job posting link: https://smma.applytojob.com/apply/mah0aDkOJ0/Sustainable-Design-Analyst

Please note that this position will support... Read more

Hi All,

If you have 5 minutes, we would appreciate your input in the Google Spreadsheet (linked below).  If you only have 1 minute, feel free to reply to this forum post and list your the typical equipment vendors you spec on projects.  :)

We're asking each of you to enter your "Top 3" specified vendors for each of the products... Read more

Folks, would love to hear what software you're for in-house daylighting/energy performance modeling at the SD/DD level. My IT folks have been pushing us to try out Autodesk's Insight again after a not so impressive pilot we did a few years ago. Has it gotten better? Was it us? What programs do you feel good about? Which ones really make you mad... Read more

Many on this list teach or have strong contacts with university programs, so I'm hoping to leverage our network in service of something that may be of general benefit.

EDR has a Research Fellowship program where we host young talent for 3 or 12 months addressing new theme each year. The Fellow(s) get "academic freedom" and have no... Read more

Dear All,

Greetings. On this Earth Day, I hope you're enjoying our planet's gifts and also giving your gift with reckless abandon.

As I take a short break to plan what I want to do next, this coming Friday, April 26, will be my last day at HKS. Maybe I will get a Hitchhiker's Guide to the Galaxy tattoo like Paula. 

I... Read more

THIS WEBINAR REGISTRATION IS CLOSED.

Wondering how LEED v5 development is progressing? Here’s your chance to find out from two of the folks who’ve been closest to the process. Join us for this 45-minute event on July 26 at 11:30 Eastern (8:30 Pacific) .

LEEDuser hosted... Read more

Ben Hewitt works behind the scenes to build and maintain BuildingGreen.com and LEEDuser. He brings with him over two decades of experience in his field. As an efficient problem-solver, his goal is to make the websites more user-friendly for his coworkers and designers and project teams using BuildingGreen’s resources.

Ben has proficiency... Read more

I am looking at having staff members take a materials course and deciding between Parsons Healthier Materials and AIA Materials Matter certificate programs. Does anyone have feedback on either? Bonus points if you know about both and can provide a direct comparison. Thanks!