Hello all!

I'm new to the group, and so excited to be here. Two part question here (as we think about processes and new year goals).

I am at a smallish firm (20 people) in Boston helping to reform our processes to enable even those that are not steeped in sustainability at a daily level to be comfortable looking for opporutunities... Read more

If anyone else has gotten confused going between parts-per-million and percentages (parts per hundred!) for material reporting here's a little infographic that might help. Feel free to use or improve! 

Good morning, All,

Just a bit of news this morning.  My family and I are moving back out west!  I am continuing in my current role with EwingCole, but will be doing so from Portland, Oregon.  Although North Carolina has a been a wonderful place for us for the past 13 years, it is time to be close to family in the northwest and southwest... Read more

We have an MEP engineer that is calculating peak loads at about 6 times passive house levels on a large commercial building that is at or near passive house levels of insulation and air infiltration. We suspect one reason is that he is figuring a 50% efficiency level for the ERV. We are showing him ERV systems with 80-90% efficiency, but they... Read more

Thanks to SERA especially David, Kira and Clark for an inspirational conversation with Paul Hawken about his latest book. I know I needed a positive perspective! Then I found this great "Regeneration Anthem" song and had to share.

https://regeneration.org/news/210915-we-can-change-world-regeneration-an...

Happy Fall to all.

Happy Thursday, all!

I will be presenting with my colleague, Emily Hoffman, and our counterpart from Seattle, Duane Jonlin, on how firms can contribute more to aggressive energy and carbon targets, from the perspective of three people that see thousands of projects each year.  We see the best and the worst, and we're convinced that our... Read more

Welcome to the quiz portion of Five Reasons to Be Optimistic About Solar Energy!

Learning Objectives
Upon completing this course, participants will be able to:


Describe three ways how PV decreases environmental impact while increasing sustainability and health measures for communities.

Discuss PV life-cycle... Read more

Hello,

We’re looking for Design Energy Code Equivalents for Chinese commercial energy codes. Do any of you have  any good sources? I’ve only found data comparing ASHRAE 90.1 2013 to the Chinese Code at that time. We understand the Chinese code require a 65-75% energy savings over the baseline but don’t have good information for defining... Read more

Hey Peer Network! Curious, if we can crowd-source a solution here for the pervious pavers at our Omaha office (climate zone 5A). Apparently over the years we've tried to add different kinds of fill here (gravel) but it keeps... disappearing. Any recommendations with either a replacement product or fill item? 

Welcome to the quiz portion of Deep Dive into the Integrative Process with Marcus Sheffer (recorded webinar)

Learning Objectives
Upon completing this course, participants will be able to:


Hi Everyone, 

Has anyone had success in finding organizations or programs that will recycle the hard hats? We are looking into options for recycling our expired hard hats that can no longer be used. Ideally, we would want to use a company with facilities across the country but we are open to any suggestions or ideas you all may have.... Read more

Poppy Gasbag

All,

I've probably spoken to a few of you over the phone, but I wanted to make sure all of you know that we are hosting a 4 part webinar series on our Tally LCA software, kicking off tomorrow 10/10. We just released the new of Tally version and ended up doing far more development work than initially anticipated, in no small part due to... Read more

Fluid-applied roofing materials can be added to an existing roof to extend its life and provide reflective characteristics.

BuildingGreen-Approved Roofing

Products listed by BuildingGreen have VOC levels below 50 g/l and reflective surfaces to reduce heat gain.

Energy Star requires initial reflectance of 0.65 for low slopes... Read more

On a large sports project, we worked with the structural engineer to spec low carbon / high SCM concrete mixes. Much of the floor area will be sealed and polished concrete, and a concrete sub is pushing back on the SCMs saying they should not be above 20% (with a preference for 0%) for the polish to finish properly, per the manufacturer. Anyone... Read more