I see that the Architect 50 questions this year are organized around AIA 2030 Commitment reporting. I have a question about how people are answering them. The DDX reports have percentages that are by GSF. Are people using this percentage to answer the questions? Or are you calculating the percentage based on number of projects out of total... Read more

Since the launch of the Contractor’s Commitment in late 2020, nineteen companies have become signatories and many others are using the guidelines as a roadmap for their firms.   Now that the pilot year of the Contractor’s Commitment is complete, it is important to consider if and how the guidelines should evolve to be the most impactful.  Over... Read more

He just posted the following on the Building Performance Knowledge Community forum:

Does anyone have a recommendation for software that is easy to use and relatively inexpensive for doing energy performance analysis at the schematic design (or before) phase?  We are looking for a tool that gives good quantitative comparisons for... Read more

Hi All,

If you have 5 minutes, we would appreciate your input in the Google Spreadsheet (linked below).  If you only have 1 minute, feel free to reply to this forum post and list your the typical equipment vendors you spec on projects.  :)

We're asking each of you to enter your "Top 3" specified vendors for each of the products... Read more

We're wrapping up a multi year project that went through multiple design changes, leaving us with a ton of material samples.  Does anyone know of a good place we could donate these samples to, to keep them out of the landfill.  I'm in the greater Seattle area.  Thank you for any suggestions.

This webcast was pre-approved for 1 AIA LU|HSW and 1 GBCI LEED-specific CE hour.

Please complete the survey questions to confirm your attendance and receive your CEUs.

By providing your credential numbers in your profile, you will enable us to automatically report these CEUs to these organizations. Please check your profile to... Read more

Howdy all,

Following up on Emily's post (https://www.buildinggreen.com/forum/aia-2030-zero-tool-vs-cbecs-baseline) on AIA2030, the folks on the steering committee's monthly call thought it'd be a good idea to do a general call for feedback on reporting this year while the bangs and bruises are still fresh. The intent is to compile the... Read more

Nadav Malin is a passionate facilitator, leading workshops and retreats to help organizations of all types find alignment, inspiration, and leadership in pursuit of their goals. He convenes peer networks of architecture firm Sustainable Design Leaders, Sustainable Construction Leaders, and others. He facilitates gatherings and consults to USGBC... Read more

Hi Friends, 

I'm working on an SOP for construction waste management for LBC core and LBC materials petal projects and wanted to get your input on the comingled facility requirements. According to the guidelines, any waste that goes to a comingled facility must be a facility that has an average diversion rate of 80% or higher as a... Read more

All,

Our firm has been struggling to find carbon reduction strategies for concrete that move us beyond a fly ash only approach. Frankly, the knowledge just isn't there internally or with our consultants. We've known that there are a few folks out there that have a deep bag of tricks, but we haven't had the chance to work with them... Read more

Welcome to the quiz portion of How To Run a Great Workshop: 37 Tips and Ideas.

Learning Objectives
Upon completing this course, participants will be able to:


1. Explain how the right mindset contributes to a successful design workshop.
2. Schedule a design workshop, set its agenda, and balance the skills of its... Read more

We are working on a large healthcare project in Minnesota.  We're setting sustainability goals a bit late - no certification, but targets with accountability.  I'm working to determine recycled steel content (for structural steel and rebar), and I've gotten a bit of push-back on recycled content based on being in the region of the Iron Range... Read more

Hello SAL Members - after last month's call, and invitation to do some thinking around the direction of the group, a few of us connected and brainstormed questions that might help guide and refine our network. It would be great to have a conversation around everyone's needs and goals, so if you could please take 5 minutes to respond to these... Read more

EDITED LINK

Hello, below is a link to our newly uploaded research report, Embodied Carbon in Commercial Furniture. This new research report introduces a case study and some new baselines for measuring the carbon footprint of commercial furniture, to add to a growing body of work on this topic among our peers:
Embodied Carbon in... Read more

Sustainable Design Leaders in NYC

New York City has been discussing implementing PACE Financing for years but has not taken action. Over 48 municipalities in New York State have PACE financing for Commercial (including multi-family) properties, it's time NYC does as well. I recently learned from colleagues in the City that all of the... Read more