As we begin to look into Scope 3 emissions reduction strategies, it's important to understand ways to reduce tranportation emissions to project sites. Is anyone aware of best practices or programs for contractor carpooling to jobsites? I know many of my colleagues travel to work together in one vehicle because of parking limitations, however,... Read more

Hello all, 

Any Fitwel experts out there? I have a 30,000 sf boutique hotel + spa client who would like to certify under the Fitwel rating system but Fitwel folks are telling me that no scorecard is currently available to hotel clients (can't use mulit-tenant or resi, that a hotel scorecard is under development). Has anyone used Fitwel... Read more

Hi: Great to see so many of you at AIA COTE Top Ten last week.  I'm forwarding the message below for those of you who know Marsha Maytum and can contribute to this important effort. Deadline is next Friday June 23rd!Thanks.

Mary Ann

Hello, friends,

During A'23, Je’Nen and I discussed our desire to send Marsha photos we have... Read more

Looking for an example or case study for a building utilizing a radiant heating/cooling in climate zone 4a. General use type is office with some public assembly spaces, total of 85,000 sf.

As usual, everyone, especially mechanical engineer, is terrified by the thought of "condensation." So far, I read a DGWW case study, "Energy... Read more

Kelly provides administrative support to BuildingGreen projects, including major contracts as well as event planning, and logistics coordination for BuildingGreen’s network of sustainable design leaders. Among her projects, Kelly coordinated a large tri-state regional economic development project focused on the green goods and services industry... Read more

Ventilation is essential for indoor air quality, but it can bring very hot or very cold outdoor air into conditioned space.

BuildingGreen-Approved ERVs

Heat-recovery ventilators (HRVs) and energy-recovery ventilators (ERVs) can save energy by capturing nearly all of the heat in the air being exchanged. BuildingGreen approves:... Read more

On LEEDuser we divide checklists into multiple project phases. Specifically:

How many of these phases are relevant for BIT best practices?

Note that we also... Read more

Hello Green Gurus,

Here is the information for our second Peer Networks Webinar this month, coming up next week: Better Products = Better Buildings (Low Carbon Specs). We hope you can join us!

Register HERE.

Better Products = Better Buildings (Low Carbon Specs)
Thursday, May 19, 2022
1 - 2pm ET (10 - 11am PT)... Read more

Welcome to the quiz portion of How To Run a Great Workshop: 37 Tips and Ideas.

Learning Objectives
Upon completing this course, participants will be able to:


1. Explain how the right mindset contributes to a successful design workshop.
2. Schedule a design workshop, set its agenda, and balance the skills of its... Read more

Hi friends,

We recently tracked our water consumption on site during the structural demolition of some existing reinforced concrete buildings.  The new OSHA silica regulations required us to keep dust to virtually zero, so we had a bunch of mist cannons and water hoses pumping water around the clock.  We consumed ~855,000 gallons in a... Read more

Hi everyone,

Thanks so much to those of you who presented at this years AIA Show & Tell, and thanks again to ZGF for hosting! Here are the slides for some of the presentations. Please do not share the slides outside of the networks unless they are marked "PUBLIC." Hope you enjoy!

Hi All, I was initially reluctant to share this, but I've seen similar posts and I think it's in line with our mission and interests so I'll go ahead with it.

Tomorrow 12/9 at 1 PM EST I'm moderating a panel of industry leaders in public health (as it pertains to buildings), construction finance, and project development to review the... Read more

Hello! 

We have several projects that are either pending ILFI Zero Carbon certification or the owner is planning to purchase offsets to cover construction emissions. Thus far, I have not considered this in our corporate footprint reporting. However, we are including A5 emissions whenever feasible and multiplying that performance over the... Read more

Hello there, 

I am working on a project with indoor plants and active green walls. I would like to design lights for growing plants and people at the same time (which seems to be a non-obvious problem). 
 

I was thinking of Philips, GE, Shneider Lighting, etc. Would you recommend someone I could talk to and eventually engage... Read more

Hi All,

Has anyone successfully adopted a Revit to ClimateStudio workflow with their new export tool? Right now we are using cove.tool because it works reasonably well with iterative Revit modeling, but are itching to try a more accurate and nuanced alternative.

Thanks for any and all experiences!
Misha

Welcome to the quiz portion of What Makes a Product Green Today?

Learning Objectives
Upon completing this course, participants will be able to:


Folks, it is with a heavy heart that I write this: Lance Hosey passed away unexpectedly on Friday. 

Many of you know him from the early days of the SDL group, or as an outsized presence at any of the many conferences where we overlap. He's been a list-maker, poll-taker and all around troublemaker in my life for over 20 years; I know I am... Read more

Hello fellow sustainable design leaders! I am about to kick off an intensive effort here at EHDD to refine our internal standards for materials. We will be considering both GWP as well as the health of materials (avoiding harmful chemicals). In addition to setting the standards, I will be working to develop a process to vet materials before... Read more