I looked through the forums and was surprised to see that from what I can tell this 2018 article from Yale I'm going to share here has not been discussed previously.  It basically says that FSC is not trustworthy, ineffective, and greenwashed, as critiqued by the likes of Greenpeace and others.

I would like to hear from someone in the... Read more

Sometimes referred to as “the dark side”, the construction industry isn’t actually so bad.  We are mostly good people.  And, we need good people. 

Consigli is hiring a Sustainability Manager to work in Massachusetts, and we could use your help to fill the role.  If you or someone you know is brimming with the sustainability force, please... Read more

I'm teaching a LEED GA study group and was rambling on the differences between CIR and precident-setting LEED Interpretation (that gets posted in the addenda library and all). Then I went onto LEED Online and was showing how those are submitted... but can't actually figure out how a LEED Interpretation would be submitted. Has anyone done this... Read more

Hi folks,

There was a lot of interest on the call yesterday in the article that Kim showed from a host of leading IAQ experts. I was not able to find a legal way to get a copy that we can share, so if you want it I think it would be appropriate to either pay the $30 for the article (one-day access ??) or $79 for a one-year AAAS... Read more

We are working on a Core & Shell project with a developer that we work with frequently. I'm looking for advice on best approaches to achieving the Whole Building Life Cycle Assessment credit- we haven't used TALLY and done this type of analysis before. What are some approaches to achieving this credit that others have found successful? I... Read more

Protection against corrosion is the primary function of steel coatings, which often contain corrosion inhibitors, volatile solvents, heavy metals, and other hazardous chemicals.

These coatings are specified when steel is used structurally, outdoors, or in high-use areas. In these situations, hazardous coatings are often applied off-site... Read more

Sign up now to roll up your sleeves and have fun solving real problems! April 28 from 3-5pm ET

DESIGNING FOR DECONSTRUCTION

Building deconstruction, or disassembly, is a critical strategy for carbon reduction, minimizing waste & contributing to a circular economy, yet remains a serious challenge for many reasons.

Many... Read more

Alena Jumplot

Hi All,

I am looking for a lifecycle analysis consultant to work on a feasibility study in New York. They should have capacity to analyze and compare various architectural, structural and mechanical components for environmental impacts, primarily GHG emissions. Any recommendations are greatly appreciated.

_Ilana

Call for Reviewers and Call for Proposals now out.  If you're not planning on submitting a proposal to present, please consider volunteering as a reviewer, subject matter expert or member of the Program Working Group.  The quality of the education program is directly proportional to the people who select it!  

See many of you in Alabama... Read more

Please see the following invite from Professor Alexandra Rempel at the University of Oregon to participate a 15-20 minute phone/Zoom interview and share your experience and/or perceptions on the problems, challenges, and barriers to incorporating into your projects.

This effort is part of an NSF research grant that I am involved in and... Read more

People tracking pollutants and dirt into buildings can cause indoor environmental quality (IEQ) problems, increase maintenance costs, and reduce the life of the floor. When they track rain and snow on hard surfaces, it increases the risk of personal injury due to slips and falls.

BuildingGreen-Approved Track-Off Systems

... Read more

Welcome to the quiz portion of Introduction to WELL Certification: On-Demand Webcast.

Learning Objectives
Upon completing this course, participants will be able to:


1.  Identify the Seven Concepts within WELL.

2.  Describe the differences between WELL and other frameworks such as LEED & Fitwel.

3.  List... Read more

Hi - we're working with the University of California Office of the President to put together low-carbon case studies. The two types we are looking for now include 1) a low-carbon TI (not a full building gut/renovation), and 2) any that involve the circular economy (in this case not just building reuse but product reuse) which could include... Read more

High-performance buildings integrate site-responsive orientation, climate-responsive form, hefty R-values, efficient mechanical systems, healthy... Read more

Greetings all, and welcome to all those who already introduced themselves!  My name is Steven Burke and I am a Sustainability Manager at Consigli Construction in Massachusetts.  We are East Coast only, but we have a few offices from DC up to Maine.  I’ve been helping Jenn and Nadav get this group up and running, and I’m relatively new to the... Read more

Hello Green Gurus!

The open Peer Networking Meetups that began when Covid-19 struck and we were all suddenly working from home have proven their value. In consultation with those who were on the last few calls we’ve decided to make them a permanent, monthly event.

Feel free to join us if you’re interested in connecting with folks... Read more