Hi all,

We have a newly constructed, core/shell project having some hot water issues in the core restrooms.

There is a 0.35 Toto lav installed throughout. The hot water heaters are adjacent on each floor, located in the janitor closets. We did the math, and there could be a gallon of water standing and cooling in the pipe between... Read more

Welcome to the quiz portion of LEDs: The Future is Here.

Learning Objectives
Upon completing this course, participants will be able to:


1. Restate the energy efficiency and long service life of LEDs.
2. Describe basic LED components and how, when assembled, they perform differently than traditional light... Read more

We have an MEP engineer that is calculating peak loads at about 6 times passive house levels on a large commercial building that is at or near passive house levels of insulation and air infiltration. We suspect one reason is that he is figuring a 50% efficiency level for the ERV. We are showing him ERV systems with 80-90% efficiency, but they... Read more

Consectetur adipiscing elit, sed do eiusmod tempor incididunt ut labore et dolore magna aliqua. Ut enim ad minim veniam, quis nostrud exercitation ullamco laboris nisi ut aliquip ex ea commodo consequat. Duis aute irure dolor in reprehenderit in voluptate velit esse cillum dolore eu fugiat nulla pariatur. Excepteur... Read more

Team,

Many of you saw this from BlackRock.

https://www.blackrock.com/corporate/investor-relations/larry-fink-ceo-letter

SOM, starting with London office, is drafting a letter to our MEP consultants, demanding and holding them accountable for climate change as a preference on consultants selection.

Best,
LL 

This webcast was pre-approved for 1 AIA LU|HSW and 1 GBCI LEED-specific CE hour.

Please complete the survey questions to confirm your attendance and receive your CEUs.

By providing your credential numbers in your profile, you will enable us to automatically report these CEUs to these organizations. Please check your profile to be... Read more

Hi SDLers! I hope early fall is finding you well.

There is a current opportunity to make a difference in the campaign to reduce use of toxic flame retardants.

Arlene Blum and the Green Science Policy Institute, whom many of you know, are currently organizing a campaign of support for the CA State Fire Marshal's proposal to allow... Read more

Exterior doors often have poor insulation and seals that allow air through.

BuildingGreen-Approved Exterior Doors

BuildingGreen has different criteria for commercial and residential exterior doors.

Commercial swing (hinged) doors must be NFRC-rated, certified, and labeled for U-factor. They have a maximum air leakage of 0.... Read more

Hello - 

I am looking for the recording and the PDF/ slides that were shared 3/6 for the project process share-out/ 5 min presentations. It was super inspiring and I would like to refresh my memory of some of what was shared. Thank you!

–
Alison Nash 
AIA, LEED AP ID+C, CPHC, WELL AP
Associate | Sustainability... Read more

We apologize, but the heating fuel cost calculator is no longer on the BuildingGreen website.

Take a look at Efficiency Maine's heating fuel cost calculator instead.

Good morning, All,

Just a bit of news this morning.  My family and I are moving back out west!  I am continuing in my current role with EwingCole, but will be doing so from Portland, Oregon.  Although North Carolina has a been a wonderful place for us for the past 13 years, it is time to be close to family in the northwest and southwest... Read more

Hello Gurus,

I have a client (bldg owner) who has asked me to recommend a list of firms who have the internalized resilient design in their practice.

They are *not* asking for resiliency consultants right now, but for firms that they might hire for "regular" capital projects, but since resiliency is high on their priorities, they... Read more

Hey y'all,

Since it's now past September 8 when reporting was due, I'm thinking all those that were going to report as part of this round have now done so. I know AIA will assemble an industry-wide report, but I'm also very interested in the less polished conversation that allows all of us to trade experiences and just see how this went... Read more

Hey all - sorry I won't be able to join our call today. I had a client request an emergency meeting today (boo) because corporate mandated that they eliminate fossil fuel use from all their buildings (yay!) by 2025 and they've got a project underway that needs to pivot quickly. 

Had I been able to join, I wanted to share this in case... Read more

Hi everyone - we have a new higher ed client who is committed to sustainability but not very knowledgeable about current topics such as carbon (both embodied and operational) or the electrification of buildings.  I need to educate them and would like to start with some easily-digestible background reading.  But as we all know, we're a bit dorky... Read more

Hi Everyone - I hope this isn't a repeat topic. We are starting to get familiar with TallyCAT at SAR+ and have a few people testing our projects in it. Is anyone willing to help us troubleshoot or share lessons learned? We're running into a few errors and wonder if our Revit models and workflow are the issue, or if we need to be doing something... Read more

Has anyone completed an LCA for an engineering structures lab, particularly one that has a strong wall and strong floor?