Thought this was worth sharing - Lance Davis, who manages the P100 program for GSA just posted to an email group i belong to that the GSA P100 program is to be updated in 2024.  In service to that, there is a "P100 Change Proposal Form" available for folks to make helpful suggestions.

They are asking for suggestions, i think we should... Read more

Has anyone used Insight for Revit to document the LEED Daylight Credit If so, would you recommend it?

Thanks,

_Ilana

You’ve probably heard that wood products are carbon neutral. You might also have heard that timber harvesting causes immense carbon emissions.

Which is it?

Could it be both?

Typically made from petrochemicals, carpet and its adhesives can offgas. It is also a challenge to recycle them, increasing the chances that it will be incinerated or disposed of in a landfill. Because carpet has a limited lifespan, its life-cycle performance is key.

BuildingGreen recommends modular carpet that demonstrates lower life-... Read more

I have been watching LEED Zero for a while, and have appreciated certain things, but one thing I think is an absolute disaster is their allowance of mainline RECs for claiming Zero Energy and Zero Carbon performance.  I just asked this question on the LEED Zero webinar, and the panelist basically said, "it's part of LEED Zero, therefore it is... Read more

Hi All - 

Has anyone explored hydronic system analysis software (1D CFD)? 

Some options are PipeFlo, AFT Fathom, PipeFlow (eerily similar name to first option), COMSOL Pipe Flow Module. 

Applications could range from general system troubleshooting, pump sizing, to district hydronic system network analysis. 

Best,... Read more

The ASHRAE Conference staff is looking for more architecture sustainability leadership for planning their Integrated Design & Construction Conference (i'm sure they'd take contractors too!). The staff do almost all of the logistics themselves but they want thought leadership from across the industry to guide the focus, content.

See... Read more

Welcome to the quiz portion of When Passive House Goes Big!

Learning Objectives
Upon completing this course, participants will be able to:


Evaluate the main barriers to achieving the Passive House Standard on a large, urban project.

Identify design strategies for successfully and cost-effectively achieving the... Read more

Hi SDL!

Our CM recently offered up the possibility of substituting Pozzotive into our structural and paving concrete mix (www.pozzotive.com) on a large public building. Apparently it is on a level with the cost of standard cement.
We are eager to reduce the project's embodied carbon, and this seems almost too good to be true.

Welcome to the quiz portion of Making Your Own Electricity: Onsite Photovoltaic Systems.

Learning Objectives
Upon completing this course, participants will be able to:


1. Explain the difference between crystalline and thin-film photovoltaic technologies, and the uses of each.
2. Describe the ways in which PV... Read more

Hello - I have met several of you virtually over the last couple years. My name is Megan Zack and I am excited to share that I have changed positions and will be the Cheif Sustainabilty Officer at Wight & Company. After spending the last 20 years working as an architect with a small percentage of my time dedicated to sustainabilty, I'll be... Read more

Hi everyone, it was so great to meet some of you at the winter summit and finally connect names with faces!

We have a project that is targeting CalGreen Tier 2 and LEEDv4 Platinum.  Thought I'd reach out to see if anyone on this forum has found comparison guides between the two?  Looking for something similar to this CalGreen 2013 tier... Read more

Some plasters have extremely high embodied energy or petroleum-based ingredients.

BuildingGreen-Approved Plaster

Products approved include:

Hello everyone!  There hasn’t been much activity on this forum in recent months, so we wanted to give an update about what’s been happening and things coming up. 

Firstly, we are very excited for the upcoming inaugural SCL Summit the day before Greenbuild.  We currently have about 20 people signed up for the Summit and we are expecting a... Read more

Curious to see if your firms have researched metals and established a preference for what you use for roof and wall panels?  I'm interested in ranking environmental performance for painted steel, galvanize steel, weathered steel, painted aluminum, zinc, etc.

Hi Green Friends - I hesitated to post on April Fools, but wanted to get the link out for folks to share with their netowrks    I'll be teaching a workshop at the Pacific Energy Center on May 11 on Electrification Retrofits of Exisitng Non-Residential Buildings.  I'll be bulidng on the great work our sub-committee led by Allison has been... Read more