Glazing connects occupants to the outdoors, but with so many opportunities for air leakage, poor insulation, and thermal bridging, glazing is the primary weak link in building energy performance.

BuildingGreen approves glazing that offers strong energy performance properties for a variety of... Read more

Hi all,

We know preparations for Greenbuild are well underway for many of you. We also know that there will be many things competing for your time while you're there. Here's one more to consider! We don't have all the details solidified yet, but wanted you to know sooner rather than later for planning purposes.

We hope you’ll... Read more

Hello all,

I need future weather files for a project. We are looking at three years, 2050, 2075, and 2095 using two climate change scenarios, low emissions, and high emissions. I have seen ARUP's Weathershift site that uses RCP 8.5 and RCP 4.5. Are we assuming that 2.6 is not achievable? I would have used this as a low emissions scenario... Read more

Hi everyone - in doing a carbon footprint for our firm, does anyone know if buildings that we design as Architects considered scope 3 emissions, or are they beyond the boundary of emissions? LMN's buildings, despite best efforts, are cumulatively multiple orders of magnitude above our scope 1 and 2 emissions. We have never included these... Read more

Hi: Great to see so many of you at AIA COTE Top Ten last week.  I'm forwarding the message below for those of you who know Marsha Maytum and can contribute to this important effort. Deadline is next Friday June 23rd!Thanks.

Mary Ann

Hello, friends,

During A'23, Je’Nen and I discussed our desire to send Marsha photos we have... Read more

We are pursuing sustainability goals (and documentation of those goals) outside of any certification/rating system for a current project.  However, we have set up a criteria list of goals by following strategies/credits from many of those systems (LEED v4 EPDs, SITES v2 threatened tree species, WELL v2 mindful eating, etc.).  This approach is... Read more

Faucets with high flow rates waste water—not to mention the energy used to treat and deliver it to our buildings—and the additional water stresses our wastewater treatment systems.

Hello SDLs!

Here is the 2018 SDL Summer Summit Report, ENJOY!

In a couple of weeks we will share this report with the broader Green Gurus group. 

We are also working on setting up a webinar to present the 2018 SDL Summer Summit Report and discuss the Summit!

All the best,

RoseAnn

Axel Slowin

On LEEDuser we divide checklists into multiple project phases. Specifically:

How many of these phases are relevant for BIT best practices?

Note that we also... Read more

Is LEED Online mind-numbingly slow today for anyone else? Or is it just me? I may give up and try again tomorrow. Frustrating as I was hoping to submit a final review today. :(

Here is a fundamental question regarding measuring operational carbon emissions that I'm sure many of you can clarify for me:  Let's say you are considering design options and you want to know the relative contribution of GWP of adding an additional inch of continuous insulation to the building envelope.  The GWP from embodied carbon will... Read more

Hello all, 

Wondering if anyone has experience with lead limits in electrical cable and wiring? 

LEED for Healthcare allows a limit of 300 ppm of lead in electrical wire and cabling - my search for compliant products has been all dead ends. (MRc PBT Source Reduction - lead, cadmium, and copper)

Acceptable regulations for... Read more

I'm working with a project team that is looking into bird control options to prevent nesting/roosting/pooping on the scrim that is designed to scrim their building's facade.  They are looking at electrified tape, repellents, laser systems, etc -- Options that don't dramatically impact the building design.  The products they're looking at claim... Read more