First, there was Energy Use reductions

Then there was embodied carbon

Soon it will be refrigerant use/leakage calculations

…and much more

As coordinators and leaders of project teams, what does this look like for the practicing architect and our collaborators?

I have no idea. BUT I’m guessing someone is... Read more

Hi all,

I'm curious if anyone has insight as to the "New Federal Building Performance Standards" that were announced in May of 2021 and then referenced again when E.O. 14057 came out. The memorandum for heads of agencies that was sent out with E.O. 14057 said that the CEQ would issue these standards, but I can't find a commitment to when... Read more

The results from the "CogFx" study are compelling, showing that people in environments with low VOCs and low ambient CO2 levels score higher on tests of cognitive function.  Specifically, they show that providing 40cfm of outdoor air per (actual live) occupant results in significantly higher scores than even the "Enhanced Ventilation" scheme... Read more

Hello, Green Gurus!
It was lovely to see some familiar faces (and names) in this afternoon's webinar about Low Carbon Specs. A little personal info, but I have just recently returned from maternity leave, and plugging back in to this network of passionate sustainability professionals is one of the things that actually made me look forward... Read more

Good daylighting intentions can end up increasing glare and solar heat gain.

BuidlingGreen-Approved Lightshelves

We look for lightshelves designed to reflect direct sunlight onto the ceiling, turning what could potentially be glare into diffuse, ambient daylight that penetrates deep into the interior of a building.

Energy... Read more

I'm writing an article surveying and comparing various embodied carbon tools, including whole-building LCA tools. I'm looking for interviewees who have used at least TWO of the three major LCA tools currently in use in North America (Tally, Athena IE, and One Click LCA). If you've tried all three, all the better! If you or someone in your firm... Read more

On LEEDuser we divide checklists into multiple project phases. Specifically:

How many of these phases are relevant for BIT best practices?

Note that we also... Read more

Hello all, 

Wondering if anyone has experience with lead limits in electrical cable and wiring? 

LEED for Healthcare allows a limit of 300 ppm of lead in electrical wire and cabling - my search for compliant products has been all dead ends. (MRc PBT Source Reduction - lead, cadmium, and copper)

Acceptable regulations for... Read more

Welcome to the quiz portion of Getting Flame Retardants Out of Foam Insulation.

Learning Objectives
Upon completing this course, participants will be able to:


1. Summarize why and how flame retardants are used in foam insulation.
2. Elucidate the case for taking the chemicals out of foam insulation.
3.... Read more

Looking for an example or case study for a building utilizing a radiant heating/cooling in climate zone 4a. General use type is office with some public assembly spaces, total of 85,000 sf.

As usual, everyone, especially mechanical engineer, is terrified by the thought of "condensation." So far, I read a DGWW case study, "Energy... Read more

Hi All, I was initially reluctant to share this, but I've seen similar posts and I think it's in line with our mission and interests so I'll go ahead with it.

Tomorrow 12/9 at 1 PM EST I'm moderating a panel of industry leaders in public health (as it pertains to buildings), construction finance, and project development to review the... Read more

Hello everyone - 

I'm writing today to let you all know that as of this month, I am retiring from SERA, and that I'm going to be beginning a new journey as a consultant/volunteer!

I'm going to continue dedicating my time to policy and advocacy work (focused on decarbonizing the built environment) but now I'll be doing it as a free... Read more

Hey group,

I'm part of the contractor team on a large commercial project pursuing LBC v3.1 Petal Certification, with one of those petals being materials. This requires the team to meet Imperative 10 Red List.

The ownership group has taken the responsibility of red list vetting as a task of their own. The construction team is to... Read more

Hello fellow sustainable design leaders! I am about to kick off an intensive effort here at EHDD to refine our internal standards for materials. We will be considering both GWP as well as the health of materials (avoiding harmful chemicals). In addition to setting the standards, I will be working to develop a process to vet materials before... Read more

Folks, it is with a heavy heart that I write this: Lance Hosey passed away unexpectedly on Friday. 

Many of you know him from the early days of the SDL group, or as an outsized presence at any of the many conferences where we overlap. He's been a list-maker, poll-taker and all around troublemaker in my life for over 20 years; I know I am... Read more

Hello Green Gurus,

Here is the information for December's Peer Networks Webinar, Architects in the Blue Zone: The AIA at COP26. We hope you will join us!

Register HERE

Architects in the Blue Zone: The AIA at COP26
Wednesday, December 15th, 2021
4pm - 5pm ET (1pm - 2pm PT)

Description

The American... Read more