Hi all,

I wanted to reach out to fellow MEP energy modeling teams to assess everyone's experience with the new PCI calculation methodology in 2016. It was a substantial change in how we show savings on projects. Big changes can often come with un-intended consequences. I'm all for pushing to higher efficiency - just want to make sure we... Read more

Sustainable Design Leaders in NYC

New York City has been discussing implementing PACE Financing for years but has not taken action. Over 48 municipalities in New York State have PACE financing for Commercial (including multi-family) properties, it's time NYC does as well. I recently learned from colleagues in the City that all of the... Read more

Has anyone submited this credit in lieu of demand response before?  I'm attempting on multiple projects but not sure what to expect review wise or how much confidence to have in the ability to get more than 1 point for trying.

https://www.usgbc.org/credits/gridoptimal-152-v4?return=/credits/New%20C...

Hi All:  We are in the design phase for a 5,700 SF project in NH. The team is taking care to drive down embodied carbon where possible. It will be NZE.

A1-A3 emissions are coming in at 67.15 kgCO2e/sf, of which 11.97 kgCO2e/sf is a hot spot attributed to permeable paving and concrete pavers (a little skewed, since lot and patio sizes... Read more

Welcome to the quiz portion of What Makes a Product Green?.

Learning Objectives
Upon completing this course, participants will be able to:


 

1. List and describe at least three attributes that address each of the following categories: "efficient use of materials"; "responsible sourcing"; "energy and water... Read more

All - 

We have corporate clients that are starting to request antimicrobials in response to Covid-19. I assume we are not the only ones seeing an increase in these requests. Knowing that the evidence supporting antimicrobials has limited to no efficacy, how are you approaching these conversations? We want to continue to advise based on... Read more

Show & Tell Break-out Session: Post Occupancy Evaluations and Occupant Behavior

Presentations: 

Preliminary findings from our first year of data collection. Measured results in WELL Stories about visiting our past clients and teaching them about their energy use habits.
 

Solvents and other hazardous ingredients contained in flooring adhesives can pose a significant health risk and compromise indoor air quality.

BuildingGreen-Approved Flooring Adhesives

BuildingGreen approves flooring adhesives that

exceed South Coast Air Quality Management District (SCAQMD) 1168 VOC content limits and also... Read more

Hi folks,

Here's the next Peer Networks private webinar. As usual, it will be recorded and shared in the network if you can't make it in person:

Thursday, July 18, 2pm EDT (11am PDT)

The Center for Active Design (CfAD), operator of the Fitwel Certification System, recently launched Fitwel v2.1, which advances a vision where... Read more

Howdy all,

Following up on Emily's post (https://www.buildinggreen.com/forum/aia-2030-zero-tool-vs-cbecs-baseline) on AIA2030, the folks on the steering committee's monthly call thought it'd be a good idea to do a general call for feedback on reporting this year while the bangs and bruises are still fresh. The intent is to compile the... Read more

Hey Team,

I'm in a Living Future session where a number of manufacturers are talking about the low uptake they're seeing in their take back programs. Contractor friends... What barriers (if any) are you running into in using take back programs? How might we as architects help increase utilization of these programs?

Aley

Hello Green Gurus.

I've been looking into EPDs lately and ran across a few companies with Product Envionmental Profiles (PEPs) which they say are also known as EPDs. Does anyone have any experience with PEPs or know if they actually are EPDs? They reference ISO standards 14040 and 14044 in the writing and ISO 14025 in the list of... Read more

Lake|Flato is growing our design performance team!  If you know any great applicants for our new design technologist position, please send them our way:

Design Technologist in San Antonio.pdf (lakeflato.com)

Returning to work: for many, it’s unthinkable without some kind of reassurance that leadership and the facilities team have taken all possible precautions. Lots of organizations are weighing in on what we should pay attention to, but how do we know if it’s working?

The free Re-entry program from Arc is a tracking and measurement... Read more

Hello everyone,

Here's a reminder that our next monthly call will be taking place next Tuesday, October 8th at 2:00pm EST.

Please feel free to join us!

Join Zoom Meeting - I double-checked this link and it is correct!

https://zoom.us/j/248664490

One tap mobile
+16699006833,,248664490# US (San Jose)... Read more