First, there was Energy Use reductions

Then there was embodied carbon

Soon it will be refrigerant use/leakage calculations

…and much more

As coordinators and leaders of project teams, what does this look like for the practicing architect and our collaborators?

I have no idea. BUT I’m guessing someone is... Read more

Has anyone used a commercial heat pump water heater for a large protect?  I have found a few manufacturers for this technology, but want to make sure this is a viable and cost approach to electrical eliminate gas on a path to all electric.

Hi: Great to see so many of you at AIA COTE Top Ten last week.  I'm forwarding the message below for those of you who know Marsha Maytum and can contribute to this important effort. Deadline is next Friday June 23rd!Thanks.

Mary Ann

Hello, friends,

During A'23, Je’Nen and I discussed our desire to send Marsha photos we have... Read more

THIS WEBINAR PURCHASE AND REGISTRATION IS CLOSED.

Glazing is by far the most complex single component of our enclosures and it must be climate-tuned to boot. Getting the amount, the location, and the performance attributes of glazing is key to... Read more

Hi all,

I'm curious if anyone has insight as to the "New Federal Building Performance Standards" that were announced in May of 2021 and then referenced again when E.O. 14057 came out. The memorandum for heads of agencies that was sent out with E.O. 14057 said that the CEQ would issue these standards, but I can't find a commitment to when... Read more

Hi everyone,

Thanks so much to those of you who presented at this years AIA Show & Tell, and thanks again to ZGF for hosting! Here are the slides for some of the presentations. Please do not share the slides outside of the networks unless they are marked "PUBLIC." Hope you enjoy!

Hello! 

We have several projects that are either pending ILFI Zero Carbon certification or the owner is planning to purchase offsets to cover construction emissions. Thus far, I have not considered this in our corporate footprint reporting. However, we are including A5 emissions whenever feasible and multiplying that performance over the... Read more

Here is a fundamental question regarding measuring operational carbon emissions that I'm sure many of you can clarify for me:  Let's say you are considering design options and you want to know the relative contribution of GWP of adding an additional inch of continuous insulation to the building envelope.  The GWP from embodied carbon will... Read more

Welcome to the quiz portion of "Spec This, Not That: Avoiding Toxic Chemicals in Commercial Building Projects"!

Learning Objectives
Upon completing this course, participants will be able to:


Hello lovely Green Gurus. Hope you all are well. I am wondering if anyone has installed an indoor sports floor that performed well and is low-emitting. This is for a multi-purpose gymnasium at a community center. Any chance?  Thanks All!

Welcome to the quiz portion of Why Post-Occupancy Review Is the Future of Design (And How It Can Serve You Now).

Learning Objectives
Upon completing this course, participants will be able to:


1. Explain the importance of post-occupancy evaluation (POE) for occupants and the opportunities in POE for architects.... Read more

Hi All, I was initially reluctant to share this, but I've seen similar posts and I think it's in line with our mission and interests so I'll go ahead with it.

Tomorrow 12/9 at 1 PM EST I'm moderating a panel of industry leaders in public health (as it pertains to buildings), construction finance, and project development to review the... Read more

The Water Sub-Group met today. This group is working on three items: 

1. Project Water Plan Template

2. Project Water Tracking Form Template

3. Research and Resources Document

The Meeting minutes are attached. The next meeting is 5/19/20 @ 2:30 PM CST, via webex and teleconference.  Please contact me if you would... Read more

We have a client who is asking us to design a roughly 10 ksf Wellness Center for PHIUS 2021 certification.  The program includes several high density assembly type spaces - roughly 300 person peak occupant load for the building.  The Criteria Calculator that the architect showed us puts the building peak cooling load at 4 BTUH/sf (3000 sf/ton... Read more

Replacing windows is expensive and comes with high impacts, but simple films can improve performance.

BuildingGreen-Approved Films

BuildingGreen approves three types of window films:

Energy... Read more