What a great first day!

Here are the slides from the show and tell presentations last night at SOM's office; everyone who presented with slides has given approval to share them.

HI All,

Really hoping to get some insight from all you wonderful people on how the Sustainability teams are set-up in your construction companies. As mentioned in my introduction post, I am the first ever Sustainability Engineer hired by my company.....until now all the work was handled by project teams. Which worked for them in the... Read more

Older buildings—especially those from the 1950s, ’60s, and ’70s—need our help. Many leave something to be desired in terms of aesthetics and comfort. But the truth is that they are part of the urban and suburban fabric now, and they aren’t going anywhere. As tempting as it might seem to tear them all down and replace them with high-performance... Read more

SAVE THE DATE: ALL Peer Networks Show & Tell
Tuesday, November 19 | 8pm - 10pm
The Kendeda Building, Georgia Tech | Atlanta, GA

Start your time at Greenbuild on a high note!

Join your Peer Networks Colleagues from SDL, SCL, MEP, SDLS, and SAL for a high energy evening full of lightning round previews of the best... Read more

Ace Brockwell

All--

I haven't been part of this group in a while, but I'm excited to have rejoined recently. Some of you know that I joined HMC last year as Chief Impact Officer. I oversee design, sustainability, research, and communications for the firm, which has 300 people in 6 offices in California. We were founded in 1940 with a mission to serve... Read more

The LBC v4.0 materials imperatives for Responsible Materials (Core) & Responsible Sourcing require a majority of wood materials (by cost) to be FSC. Sure. But what is - or isn't - considered wood? The Clarification page for the imperative's scope and a key definition poses a perplexing conundrum: 

"All wood included in the Materials... Read more

Hello friends, Posting this to help out a friend that you all know!

(please reply directly to Kira at her email below) Tx

Dear Gurus, 

I am curating/hosting a panel at CarbonPositive RESET:

DESIGNED FOR CLIMATE: A New Construction Showcase

North & South America: September 8, 2020 | 4:45-5:25pm (PST)

Hi: SD Leaders.  It was so nice to see so many of you at Greenbuild in Chicago. By now I'm sure all have seen the announcement of the release of the Fourth National Climate Assessment Report vol 2. (https://nca2018.globalchange.gov/) It's well worth a deep read - so much important and extremely informative material. I want to draw your... Read more

We have a project looking to use Radiant Floors to help with space heating.  I don't have experience with this so I'm looking for any insights.  Pros / Cons? 

This project is a non-profit and is needing to reach LEED Silver minimum.  This is in Washington State.  Thank you for your help.

Early laminate flooring had problems with premature surface wear, moisture damage, and hazardous formaldehyde emissions—and some products may still have these problems.

BuildingGreen-Approved Flooring

Laminate flooring products listed by BuildingGreen have high recycled content (greater than 70%) or FSC-certified content and:... Read more

Welcome to the quiz portion of What Makes a Product Green?.

Learning Objectives
Upon completing this course, participants will be able to:


1. List and describe at least three attributes that address each of the following categories: "efficient use of materials"; "responsible sourcing"; "energy and water... Read more

Folks,

In case any of you enjoy the Phoenix weather, I wanted you to be sure to know that our company, Sundt, which is headquartered here is looking for a sustainability director to lead up our efforts. This comes after two years of work and hiring a consultant (Brightworks out of California) to help us prepare and take the next steps. I... Read more

Hi All,

Polling the group to see if anyone has experience with Simergy - an e+ based modeling tool?

The tool appears to have features and integration with a lot of e+ plugins that make it attractive - but i haven't heard of its widespread use.

Is anyone successfully using Simergy?

Hey Gurus:

I have a client who is interested in reporting to their superiors on the status on energy codes in different states across the US. They are hoping to find some kind of summary that might show relative costs for HVAC systems under the various energy codes in effect across states. They are also interested in data that is... Read more

We just heard from one of our more progressive clients that they are pulling Mohawk from their shelves and are no longer allowing it on their projects. Apparently there are some chemical ingredients they objected to, but more importantly the manufacturer "lied" to the client about the content. Does anyone have an idea what this might be about?... Read more