We have an MEP engineer that is calculating peak loads at about 6 times passive house levels on a large commercial building that is at or near passive house levels of insulation and air infiltration. We suspect one reason is that he is figuring a 50% efficiency level for the ERV. We are showing him ERV systems with 80-90% efficiency, but they... Read more

Hi, folks! 

I was recently asked if BuildingGreen could connect prospective speakers to an event organizer in Chicago. Beyond the leaders in the BuildingGreen networks relayed, I wanted to share that the exercise led me to the Women and Climate speaker database: https://www.womenandclimate.co/speaker-database 

When filtering by... Read more

Welcome to the quiz portion of "How to Access the Full Power of Biophilia."

Learning Objectives
Upon completing this course, participants will be able to:


Good Morning everyone.  i just wanted to send Congratulations out to the new class of fellows, with a shout out to Jonathan Weiss, Paul Hutton, and Ramana Koti.

Well done Gentleman!

Hello,

We’re looking for Design Energy Code Equivalents for Chinese commercial energy codes. Do any of you have  any good sources? I’ve only found data comparing ASHRAE 90.1 2013 to the Chinese Code at that time. We understand the Chinese code require a 65-75% energy savings over the baseline but don’t have good information for defining... Read more

Has anyone found any options to recycle safety vests, or discovered an upcycling option for them?  We are about to replace all of our vests company-wide and will have thousands that we don't want in the waste stream and we don't want to be reused as safety vests.  Any thoughts or ideas would be great!

Thanks and I hope everyone is... Read more

Hi everyone,

Have your projects explored, pursued, or successfully achieved the domestic content bonus for PV systems within the Inflation Reduction Act (IRA) Investment Tax Credit? I have a project that is considering adding the IRA domestic content requirements and we are trying to understand the nuances and potential challenges (cost... Read more

Dear SLD-ers,

We have a project team considering the use of copper cladding for a high profile project in Vancouver. The preference is to use pure copper that is pre-patinated and does not have additional coatings.

We are attending a CEU from the Copper Development Association to understand options and environmental impact, but we... Read more

All,

I recently met Sahil Tadwalkar who is a Stanford MS Candidate in Civil Engineering. He and his group are interviewing design and construction industry professionals to understand issues and challenges around specifying and using low carbon solutions on projects. Interesting stuff! I encourage you to contribute by setting up an... Read more

Welcome to the quiz portion of What Makes a Product Green?.

Learning Objectives
Upon completing this course, participants will be able to:


1. List and describe at least three attributes that address each of the following categories: "efficient use of materials"; "responsible sourcing"; "energy and water... Read more

I know that there is a risk of starting a whole flurry of congrats through the forum, but this is a biggie, and deserves some recognition:

Congratulations Andrea and Melanie!! Huzzah!!

And a reminder--If you want to reach out to them privately, rather than through the forum, with your message, you can see anyone's email address by... Read more

Hello Sustainable Community Design Leaders!

I have an exciting announcement today, fall Peer Network events are now open for registration! You can see all the event details and register here!

Based on feedback we received from past events and the most recent surveys, we decided against doing one long week of events for this fall... Read more

Exterior doors often have poor insulation and seals that allow air through.

BuildingGreen-Approved Exterior Doors

BuildingGreen has different criteria for commercial and residential exterior doors.

Commercial swing (hinged) doors must be NFRC-rated, certified, and labeled for U-factor. They have a maximum air leakage of 0.... Read more

The BuildingGreen Guide to Thermal Insulation provides detailed guidance on insulation products and practices, including recommendations on what insulation to use and what to avoid. It's a treasure trove of information for architects and designers, builders, and anyone who is actively considering the impact of insulation on the quality of your... Read more

Jenny/Dan:

What types of content do anticipate having in the Documentation Toolkit tab? Here's an example of what we have on LEEDuser:

https://leeduser.buildinggreen.com/credit/EBOM-2009/SSc5#tab-docs (login required)

The layout is a little complicated on LEEDuser, since we had to work with a lot of legacy content, but... Read more

Hi SDL: today is the last day to cast your vote in the voting for Greenbuild by 5PM ET.  

please vote for the terrific program put together on PV23 "The Tools You Need to Design for Climate Emergency Action" with me, Betsy and Beth Heider that will bring together a collection of tools, including brand new ones from Saskia, using the Top... Read more

Hi Everyone!  About ten days ago, Megan Zack posted a note announcing her new role as Chief Sustainability Officer at Wight & Company. (Yay!)  I'm so delighted that she will be stepping into this leadership role at Wight to shepard the firm in the next chapter of their journey in sustainability. 

I wanted to take a moment to say... Read more