Hello everyone!

The Sustainable Design Leaders Summit will be kicking off with a Pre-Summit workshop in Seattle July 31st, 9am - 3pm. If you are interested in joining your peers for this workshop, please see the registration link below. Also, if you know someone in the Seattle area that would be good to have in the workshop and might be... Read more

Typically made from petrochemicals, carpet and its adhesives can offgas and it is a challenge to recycle, increasing the chances of it being incinerated or disposed of in a landfill. And broadloom carpet can difficult to repair if damaged.

BuildingGreen approves modular carpet that demonstrate lower... Read more

It’s Earth Day! In celebration, we’re offering full Premium subscriber access to BuildingGreen content, news, and product guides for all Peer Network members for the next six months. 

We’re sharing this unbiased, rigorous content with you through the coming summer and fall, with access to our: 

Premium content, guides, and... Read more

Hi all!

A couple years ago now there was an incredible thread here about circadian lighting design and WELL. There was a lot of dipping toes in the water with intent to gather lessons learned and report back.

What have been the high points and low points of circadian lighting design so far? What seems cost-effective and worth... Read more

Is anyone else working on a project doing Living Building Challenge v4.0 Energy Petal? We're working through the Imperative 08 Net Positive Carbon Resiliency Strategy requirements that ask for the project to be habitable for a week in the event of an emergency. We're curious how others are defining "habitable" and what systems assumptions... Read more

Anyone have experience with electric boilers? I think in cold climates it's perhaps the first thought when trying to reduce scope 1 emissions in an HVAC application that would have historically used gas-fired boilers... but it seems like they're only an incremental improvement compared to heat pumps / geothermal / VRF type solutions. We haven't... Read more

Wellness is key to sustainable design. As more and more clients understand the value of healthy built environments, designers need to understand the various wellness rating systems available, and which would meet the project's goals and needs.

WELL and Fitwel have emerged as the two leading wellness rating systems,... Read more

Happy Friday, SDL!

We're running a Tally WBLCA for an environmental education center, which has a very small floor area but a fairly robust concrete/steel structure. Still, I was surprised to find an intensity of over 1,000 kgCO2/m2 for the building.

This is way higher than the general benchmarks I've found in the CLF's database,... Read more

This month on our Sustainable MEP Leaders call we were asked what resources would be suggested for advancing integrative design.

Two books immediately came to mind for me:

How Building Learn, by Stewart Brand

https://en.wikipedia.org/wiki/How_Buildings_Learn

It was many years ago but reading Stewart Brand’s How... Read more

Hello all,

Could any of you point me out to recent studies showing the health impacts of plastic piping vs. copper piping? 

We have a project where NIRON or Aquatherm are proposed as a VE item in lieu of copper.  I know there is some studies showing PEX and PVC piping health impacts, but I can't seem to find anything on these 2... Read more

Hello, I'm wondering if anyone out in the network has experience with the following:

>Low carbon concete mixes for polished concrete slabs: we're hearing concerns from our concrete supplier that using a low carbon mix design for a polished concrete slab will cause pitting. What experience do others have?

>Low carbon concrete... Read more

Can you comment on successful ways you have used eQUEST and pitfalls you have seen? We are considering training our architects to use it for early building analysis on all projects. 

Welcome to the quiz portion of Exterior Paints: Long-Term Protection and Environmental Tradeoffs.

Learning Objectives
Upon completing this course, participants will be able to:


1. List the primary differences between alkyd and latex paints and stains and between wood, concrete, and metal primers.
2. Explain... Read more

Hi,

I have a colleague doing research on PCM in several projects. For context in their report, they were wondering if this group has seen any recent increase in application of PCMs in recent years. Is it just in ceilings or other applications? If so, what products are being used? They were having difficulty finding manufacturers other... Read more

I have been watching LEED Zero for a while, and have appreciated certain things, but one thing I think is an absolute disaster is their allowance of mainline RECs for claiming Zero Energy and Zero Carbon performance.  I just asked this question on the LEED Zero webinar, and the panelist basically said, "it's part of LEED Zero, therefore it is... Read more