We are having trouble sourcing a LEED compliant wallcovering adhesive. We specified Roman Pro-880 which is low VOC but doesn't have sufficient back up for TVOCs. Have you had success with other products?

Welcome to the quiz portion of Saying Goodbye to the Office—and Hello to Housing!

Learning Objectives
Upon completing this course, participants will be able to:


People tracking pollutants and dirt into buildings can cause indoor environmental quality (IEQ) problems, increase maintenance costs, and reduce the life of the floor. When they track rain and snow on hard surfaces, it increases the risk of personal injury due to slips and falls.

BuildingGreen-Approved Track-Off Systems

... Read more

Hello all!

I'm new to the group, and so excited to be here. Two part question here (as we think about processes and new year goals).

I am at a smallish firm (20 people) in Boston helping to reform our processes to enable even those that are not steeped in sustainability at a daily level to be comfortable looking for opporutunities... Read more

We have an MEP engineer that is calculating peak loads at about 6 times passive house levels on a large commercial building that is at or near passive house levels of insulation and air infiltration. We suspect one reason is that he is figuring a 50% efficiency level for the ERV. We are showing him ERV systems with 80-90% efficiency, but they... Read more

Protection against corrosion is the primary function of steel coatings, which often contain corrosion inhibitors, volatile solvents, heavy metals, and other hazardous chemicals.

These coatings are specified when steel is used structurally, outdoors, or in high-use areas. In these situations, hazardous coatings are often applied off-site... Read more

Hi All,

Has anyone dug into ASHRAE 2016 as part of the new v4.1 requirements or as codes start to adopt it? I recently presented on this and thought I should check my math to make sure I'm understanding and communicating this correctly.

My understanding is that there is a new reference baseline, that is essentially the ASHRAE 2004... Read more

Hello,

We’re looking for Design Energy Code Equivalents for Chinese commercial energy codes. Do any of you have  any good sources? I’ve only found data comparing ASHRAE 90.1 2013 to the Chinese Code at that time. We understand the Chinese code require a 65-75% energy savings over the baseline but don’t have good information for defining... Read more

Hello - 

I am looking for the recording and the PDF/ slides that were shared 3/6 for the project process share-out/ 5 min presentations. It was super inspiring and I would like to refresh my memory of some of what was shared. Thank you!

–
Alison Nash 
AIA, LEED AP ID+C, CPHC, WELL AP
Associate | Sustainability... Read more

On a large sports project, we worked with the structural engineer to spec low carbon / high SCM concrete mixes. Much of the floor area will be sealed and polished concrete, and a concrete sub is pushing back on the SCMs saying they should not be above 20% (with a preference for 0%) for the polish to finish properly, per the manufacturer. Anyone... Read more

Hi Everyone, 

Has anyone had success in finding organizations or programs that will recycle the hard hats? We are looking into options for recycling our expired hard hats that can no longer be used. Ideally, we would want to use a company with facilities across the country but we are open to any suggestions or ideas you all may have.... Read more

Here's the Core Purpose for this group that came out of the Inaugural Summit.

We're off and running!

BUILDINGGREEN

WELL AP Practice Guide - Site License

BG Premium Monthly Membership-Individual (auto-renewing)

BG Premium Yearly Membership-Individual (auto-renewing)

... Read more

Welcome to the quiz portion of How Buildings Fail Their Users!

Learning Objectives
Upon completing this course, participants will be able to:


Explain the importance of finding common ground between a client’s project goals and the project team’s sustainability building goals for successful projects that incorporate... Read more

Are there any metrics for % increase for building PH vs conventional?  These questions are always really hard- especially when there are none to compare to in area.

Here are the links I mentioned at today's meeting:

Timeline:
https://docs.google.com/presentation/d/1RlN4t23uvBtxEzp4QuyqL-w5bqmE4P90...

BG Contacts and Responsibilities:
https://docs.google.com/document/d/1MWYuAEitjk7Zpc8KUNf1LwG3-5wK6sIlgwro...

BITuser Contacts and Responsibilities:
https://docs.google.... Read more

Erika Heet is the Editor-in-Chief of BuildingGreen. She is the former Editor-in-Chief of Interiors magazine. She has held senior editor positions at Dwell and Architectural Digest, and is the author of two books on modern architecture. She has served on the boards of Greenbuild and the Sustainable Furnishings Council, as well as on juries for... Read more