The BuildingGreen Guide to Thermal Insulation provides detailed guidance on insulation products and practices, including recommendations on what insulation to use and what to avoid. It's a treasure trove of information for architects and designers, builders, and anyone who is actively considering the impact of insulation on the quality of your... Read more

We're wrapping up a multi year project that went through multiple design changes, leaving us with a ton of material samples.  Does anyone know of a good place we could donate these samples to, to keep them out of the landfill.  I'm in the greater Seattle area.  Thank you for any suggestions.

We had so much fun at our Contractor coffee talk that I reached out to our MEP friends to see if they would set up something similar.  And they have agreed to host a talk on Thursday December 2, at 1-2pm EST.  They will talk about decarbonizing buildings, on a schedule that keeps us under the 1.5° C limit and will also address strategies for... Read more

We are cautiously rekindling the age-old debate: how are we balancing modeling software for design /visualization and performance analysis during early phase of design.  

We are heavy SketchUp users for early design, and most of our staff have access to COVE tool for early performance analysis. Problem is, I’d rather use Revit to COVE... Read more

Alerting building occupants about indoor air pollutants is important in many situations.

BuildingGreen-Approved IAQ Equipment

Products approved by BuildingGreen range from single-use test kits to monitoring systems installed throughout a building. Some test for gases such as radon, VOCs, or carbon monoxide, and some for mold and... Read more

Hi Friends, 

I'm working on an SOP for construction waste management for LBC core and LBC materials petal projects and wanted to get your input on the comingled facility requirements. According to the guidelines, any waste that goes to a comingled facility must be a facility that has an average diversion rate of 80% or higher as a... Read more

Many on this list teach or have strong contacts with university programs, so I'm hoping to leverage our network in service of something that may be of general benefit.

EDR has a Research Fellowship program where we host young talent for 3 or 12 months addressing new theme each year. The Fellow(s) get "academic freedom" and have no... Read more

Hello all,

I am reaching out to this community as SMMA has a job opening for a Sustainable Design Analyst (like many of you recently posting job openings on this forum).

Here is the job posting link: https://smma.applytojob.com/apply/mah0aDkOJ0/Sustainable-Design-Analyst

Please note that this position will support... Read more

I've been hearing recommendations for bipolar ionization, as a way to filter airborne virus particles in HVAC systems while avoiding the energy penalty of increased ventilation. However, I've also heard that ionizing equipment is dangerous because it produces ozone.

Does anyone have any insight into the effectiveness and/or cautions... Read more

Was anyone else surprised to see ASHRAE 228-2023 using eGRID Subregions for both the Regional Electricity Source Energy Conversion Factor and Regional Electricity Greenhouse Gas Emission Factors? In the past I have used eGRID sub-regions but also State and local utility conversion factors depending on what energy or operational carbon story I... Read more

Something we seem to be seeing a lot in our market recently are projects split into multiple packages - footing / foundation, C&S, and then later a TI package of CD's... mostly in an effort to speed up permitting and construction schedules. (Oftentimes with a contractor on board for a design / build approach). 

My question to the... Read more

He just posted the following on the Building Performance Knowledge Community forum:

Does anyone have a recommendation for software that is easy to use and relatively inexpensive for doing energy performance analysis at the schematic design (or before) phase?  We are looking for a tool that gives good quantitative comparisons for... Read more

Does anyone have an idea when the AIA Materials Pledge Reporting Framework will be available? Or is there a draft of what it looks like? 

BWBR is on a push to refine our approach towards materials. As AIA Material's Pledge signatory, we were hoping to incorporate the reporting framework into our efforts. Trying to get a sense of the... Read more

Katherine keeps BuildingGreen’s physical and digital spaces running smoothly. A graduate with honors from the University of Iowa, Katherine has a background in filmmaking and administration. She lives in southeastern Vermont with her partner and enjoys hiking, board games, writing, and cats.