I am looking for example specifications for low carbon concrete to have our structural engineer(s) review and incorporate.  Does anyone have good examples or  link(s) to good examples?

Thanks,

Mark

Reaching out to the collective knowledge here.  With interest in circular economy and building reuse growing, is anyone leading the charge for the concept of building reuse as a tool for maintaining community identity?  Has anyone seen successful projects with this concept in mind?  I was just in a discussion with a bunch of SDLers, and while... Read more

I read a very misleading article on the AIA's website today regarding antimicrobials and the benefit of microbicidals in paint. It was written by a manufacturer, not a healthcare professional, and was not obviously labeled as sponsored content on the website. (I received the link in an email, which did label it as such).

https://www.aia.... Read more

Hello All,

A group of us (three architects and a builder- sounds like there should be a joke here) were debating this and we  are stumped.

Application: Residential exterior trim.

50 year warrantied composite product of agricultural byproduct with PVC (EPD not published yet) vs 100 year (if primed on all sides and painted or... Read more

Hello, does anyone have experience with thin film solar? We're looking to add it to a city wide bus station application. Thanks!

Allen Mutapo

Welcome to the quiz portion of Fundamentals of High-Performance Building Assemblies.

Learning Objectives
Upon completing this course, participants will be able to:


1. Recall how the acronym ENDURE speaks to the unifying aspect of high-performance buildings.
2. Describe how to apply the principles of high-... Read more

Welcome to the quiz portion of Wood: What’s Good?

Learning Objectives
Upon completing this course, participants will be able to:


CEUs are available for reading all the building-envelope product guides and primer. Click here to learn more and take the quiz.

Water and air that penetrate building assemblies can damage materials, cause energy loss, and lead to mold, mildew, or other problems. The products used to address these may contain materials that are... Read more

We're expanding the capacity of our team, with two positions, a general project sustainability specialist as well as a more targeted position focused on the healthcare sector.

Healthcare Sustainability Specialist

Sustainability Specialist

In both cases, we're looking for smart, experienced people who understand the power... Read more

Hey there, SMEPLs:

Just a reminder that we are on the menu for the next in the Green Gurus Coffee Talk series. 

Please use this link to register

All the SMEPLs are invited to join in the conversation where we talk about things that rumble, squeal, gurgle and spark to our peers in the Design, Construction and Advisory peer... Read more

Anyone using the USG EcoSmart drywall? I'm writing a short product review and am looking for some quick feedback. I'm particularly curious about reduced greenhouse gas emissions and overall cost. Thanks! Brent

Hello Sustainability Leaders,

Great to see some of you at Greenbuild last week.  Thanks to all who responded to Nadav’s post-election blues post.  Lots of helpful insights and sentiments that left me very grateful to be part of this community.  On a related note, since the election I’ve been asked by people in our office and in life if... Read more

With the increasing need to support design with techncial expertise, I am curious to hear how others are meeting this challenge.  Do you build energy models in-house?  Do you have a team of experts whose sole responsibility is to support design teams with tasks such as energy modeling and LCA, or is that expertise distributed throughout the... Read more

Hi all - has anyone worked on a project with thermal energy storage tank design in the scope?  I'm wondering if anyone has recommendations for specialists or engineers who have experience.  Thanks!