Do any of you have experience with Design For Freedom yet? It came to my attention and I'm trying to investigate. I would love to hear feedback and experiences that you may have at this point. It seems like an opportune moment for this issue of forced labor (yikes! so much I don't know...) to come to the forefront, and I'm curious to hear how... Read more

* This gets complicated -- how much should happen on the dashboard and how much should happen in the actual Discussion forum?

Hold off on discussions for Phase 1. What should be here instead for... Read more

For a number of years a colleague and I have been teaching a course about sustainability and water in architecture at the University of Pennsylvania's architectural school (PennDesign).  This year we're hoping to bring a few new opinions to the table for at the same time as we broaden the discussion.  Because the class will be virtual again... Read more

Alena Jumplot

Dear all,

On a major renovation where the wall R-value/U-value needs to be brought up to energy code, specifically a mass wall situation, does anyone have insights on how the situation is best dealt with? On the project in question for me, the continuous insulation might have to be added to the inside surface of the mass wall and there... Read more

As I mentioned in my five-minute presentation this morning and then discussed a little more in the break-out on RELi that followed, the full RELi Rating System, in its current form, has now been posted online: http://anyflip.com/zyqc/mdir/

Unfortunately, this is only posted as a flipbook, currently (viewable online only), and isn't... Read more

We are trying to figure out how we are going to meet the LEED Credit for Building Life Cycle Impact Reduction for the first time.

One approach we're trying out: We're taking the results of our Tally model and looking at potential reductions from low-carbon concrete. However, the problem I am encountering is that when I take some of our... Read more

Welcome to the quiz portion of Mouth, Meet Money: Case Studies of Outcome-Based Design!

Important: This quiz covers all related articles within this topic. Scroll to the bottom of the article page to find links to all the articles covered by this quiz.

Learning Objectives
Upon completing this course, participants will be... Read more

Hi all, 

Thank you again to those of you who attended the Spring 2024 SCL Summit! We had an amazing day of learning from one another, including from our presenters.

The slides for the 5-minute presentations are below, as well as the BuildingGreen slides from the Summit. Please be aware that we have permission from all of the... Read more

Here is your friendly reminder to complete the SCL Salary Survey if you have not yet.

There is a link at the end of the SurveyMonkey Survey to a Google form where you will be able to register that you completed the survey—that way we’ll know who participated without having any identifying info in the actual survey. Results will be shared... Read more

I can hear Kjell saying "All models are wrong, but some are useful." Having said that we are having trouble getting usuable predictive energy use information from our electrical design engineer. They are telling us that their energy models are not for accurate pEUIs but just to compare various scenarios. Are they being lazy? Should we push for... Read more

There has been a lot of discussion re antimicrobials in this group, so here is a pre-release of this month's article on the topic. It's not an extensive feature, but I hope you find it informative.

Brent

We're wrapping up a multi year project that went through multiple design changes, leaving us with a ton of material samples.  Does anyone know of a good place we could donate these samples to, to keep them out of the landfill.  I'm in the greater Seattle area.  Thank you for any suggestions.

If your HVAC designers are addicted to the crack that is Trace 700, and knowing that Trane is giving up on that product in the coming year, what loads program are you weaning* them onto?

Asking for a friend:  Have any of you had success in using the Revit plug-in for loads?

*When told that they should use IESVE for loads, our HVAC... Read more