I give you... the content-ready site. The editors should be able to start adding Best Practice content.

Development site: 
https://live-bituser.pantheonsite.io/

Instructions (with tutorial videos):
https://docs.google.com/document/d/1EUIzitkW0CczFQo8V2q3gVDVO4Juk4EI9iv8...

I created accounts for all the editors... Read more

CEUs are available for reading our entire plumbing guide. Click here to learn more and take the quiz.

Rainwater capture is increasingly important as shortages put pressure on our water systems.

BuildingGreen-Approved Rainwater Harvesting

We approve a wide range of rainwater catchment and storage systems and components, with... Read more

I am dual posting a topic from the SDL forum in the Green Commons. Sorry to those who see this twice but I'm trying to cover more ground.

The first post from Mike Manzi ... 

SDLers,

Great to see many of you at Greenbuild! It was nice to have the opportunity to remind everyone how our collective energy continues to make a... Read more

Hello Green Gurus! We are diving deep into our carbon metrics this year and are finalizing some of our emissions factors for our Scope 1 and 2 emissions and in a few more months Scope 3. I'm hoping this brain trust has some recent knowledge to share on this topic. What we've found is there's a fairly big variance in what we've seen in published... Read more

Hello,

We are in the very early planning phase of a k-8 public school project to be designed and built in an economically challenged urban location with very limited site options. The project is not LEEDv4 registered yet.  We are at feasibility and costing the soil remediation, needless to say that we would really hope there would be... Read more

He just posted the following on the Building Performance Knowledge Community forum:

Does anyone have a recommendation for software that is easy to use and relatively inexpensive for doing energy performance analysis at the schematic design (or before) phase?  We are looking for a tool that gives good quantitative comparisons for... Read more

Welcome to the quiz portion of Lighting Design for Health and Sustainability: A Guide for Architects​!

Learning Objectives
Upon completing this course, participants will be able to:


Describe how high-quality lighting design dovetails with sustainability by improving energy efficiency and supporting occupant health and... Read more

We are putting together a free guide for firms who have not yet started to figure out what their internal standards are for healthy, low carbon materials/products. 

As part of this effort, we are looking to gather from all of you who already have standards - examples and precedent.

Also we are collecting standards from clients/... Read more

Hi all,

We recently learned that Mass Dept of Environmental Protection (MassDEP) along with a few other state agencies are looking to offer grants for wastewater heat recovery implemented into projects. This is a newer technology that puts a heat exchanger or heat pump in the wastewater system that then extracts the heat energy and... Read more

Hi All - I wanted to share out the All For Reuse initiative below by two peers in the sustainable materials management network. I know some SDL have already done much research on this from quite a few angles, and those with LBC experience probably even moreso in practice. 

Frances Yang (Arup) and Andrew Ellsworth (Doors Unhinged) have... Read more

Welcome to the quiz portion of The BuildingGreen Guide to Insulation!

Learning Objectives
Upon completing this course, participants will be able to:


1. Discuss how insulation works to increase the energy efficiency and environmental sustainability of buildings; 
2. Explain why certain materials make more sense than... Read more

We are working on a large healthcare project in Minnesota.  We're setting sustainability goals a bit late - no certification, but targets with accountability.  I'm working to determine recycled steel content (for structural steel and rebar), and I've gotten a bit of push-back on recycled content based on being in the region of the Iron Range... Read more

Hi all,

AGC is the biggest umbrella organization for general contractors in the states. To date, there has been practically no interaction between the SCL and AGC. In my mind, the SCL group is the most knowledgeable group of dedicated sustainability professionals out there; so is there a way that we can partner with AGC to collaborate ... Read more

Hello SDL Peers,

We are currently in the process of expanding our firmwide carbon reporting (and goal setting). I am looking to see if anyone has some "best practices" or examples of their own firm's journey to carbon neutrality. Any info or tips are welcome!

Thx, JP

Hello all,

I am reaching out to this community as SMMA has a job opening for a Sustainable Design Analyst (like many of you recently posting job openings on this forum).

Here is the job posting link: https://smma.applytojob.com/apply/mah0aDkOJ0/Sustainable-Design-Analyst

Please note that this position will support... Read more

RoseAnn’s role at BuildingGreen as Peer Networks Manager focuses on Peer Networks projects and planning events, including annual Peer Network Summits. 

Prior to BuildingGreen, RoseAnn worked in the nonprofit sector in customer-service based roles which allowed her to reconnect with her local community soon after earning her... Read more