Championing the
Changemakers

A couple questions for this group. I know we're having a Green Commons meeting on this next week. But can anyone comment on the following questions?

-Have you or your firm split the benefit of the 179D with a client? Is this typical?

-Is prevailing wage a requirement for all 179D benefit, or does it follow the same lines as... Read more

Hi Friends, 

I'm working on an SOP for construction waste management for LBC core and LBC materials petal projects and wanted to get your input on the comingled facility requirements. According to the guidelines, any waste that goes to a comingled facility must be a facility that has an average diversion rate of 80% or higher as a... Read more

Hello friends,

Anyone who will be attending NESEA's BuildingEnergy Boston conference next week is invited to an informal Green Gurus meetup! Stop by the Built Environment Plus booth (#4 on the map) at 6pm Monday (during the second half of the trade show reception) to say hi to some fellow Sustainability Leaders. SDL member Keihly Moore... Read more

Hi All,

Attached are the meeting notes from the Carbon Group's 2/26/20 -- also in the PDF are the slides presented in the 2/26 meeting.

Before our next meeting in late March/early April, we are looking for input on the following topic related to tracking and reporting carbon:

Wood decking requires potentially hazardous preservatives and stains, and plastic waste is a significant environmental problem.

BuildingGreen-Approved Decking

Composite decking approved by BuildingGreen has at least 50% total recycled content. For plastic decking, post-consumer content has to be greater than 50%.

Health and... Read more

All, today is the day I had committed to sending out the DRAFT request to equipment manufacturers of what is needed for full electrification.  I apologize that I didn't have time or focus to get my thoughts together till now (I had intended to share this with Chris and others prior to sending to the full group, but just didn't get my thoughts... Read more

Welcome to the quiz portion of Fundamentals of High-Performance Building Assemblies.

Learning Objectives
Upon completing this course, participants will be able to:


1. Recall how the acronym ENDURE speaks to the unifying aspect of high-performance buildings.
2. Describe how to apply the principles of high-... Read more

Hi - We have some projects within reasonable reach of ILFI's Zero Carbon Certification, which will require purchasing some off-site renewable energy. As a State Building Code Council member, I'm also eyeing the Zero Code which we will seriously consider in the next 12 months; this also requires a purchase of off-site renewable energy. 

I... Read more

Hi All,

I just tried to post a minute ago but it said my connection was lost, so I'm starting over again. You may see two similar posts from me.

Alejandra and I started a document (attached) with ideas on how we can tackle some of the issues we are currently facing with zero waste, as a follow up to our conversation last Friday... Read more

We are cautiously rekindling the age-old debate: how are we balancing modeling software for design /visualization and performance analysis during early phase of design.  

We are heavy SketchUp users for early design, and most of our staff have access to COVE tool for early performance analysis. Problem is, I’d rather use Revit to COVE... Read more

Hi,

Are any of you attending this conference? Michelle and I are doing this low-carbon concrete/EC policy work and can't attend this conference on short notice - but if YOU are attending - we might ask a couple of small favors (collecting specific info from trade show etc)

AND/OR: if any of you have attended in the past - was it... Read more

Hi Gang, 

We are looking to implement the contractor commitment and are running into COVID-19 protocol barriers when looking at the Jobsite Wellness category specific to the soap as well as the food storage/eating areas on site. Anyone else run into this issue? 

-Kena 

Hi folks,

Mahesh announced today that he's leaving his position as CEO of USGBC, GBCI, and ArkScoru, effective Nov. 1. An interim CEO will be announced tomorrow.

I think that Mahesh did some great things for the organization(s)--and he had some really loyal team members. He could also be challenging to work with--as I learned... Read more

Hi,

There is a Blog section on the BIT User site. Will you have a blog post in time for launch? Or should we hide that section to begin with?

https://live-bituser.pantheonsite.io/blog

Andrea

Hi all,

We're doing some tool-related soul searching at WRNS and some folks here have raised Cove.Tool as a potentially interesting addition to our library. I'm looking for any insight you all can provide. Cove has come up various times, but curious if there's been any change for the better/worse in the past few years.

Do you use... Read more

Hello, 

We are becoming involved with the design/construction of a new k-12 school that is intersted in entertaining geothermal. Does anyone have payback studies on geothermal?

Thanks!