Championing the
Changemakers

A new article addressing whether PFAS finishes on upholstery fabric actually work (Spoiler alert - they don't) has been published and can be found here:

https://journals.sagepub.com/doi/10.1177/24723444231159856

This is authored by the fine folks at Green Science Policy, Arlene Blum's group that is the source of the Six Classes of... Read more

This is a test for surveys.

There are a number of clear finish options available, from natural oils and low-toxicity products primarily used on residential woodwork through factory-applied finishes where specific aesthetics and/or added durability are required (such as those used on cabinetry or commercial architectural millwork). Many of these have very high VOC levels,... Read more

HI Green Gurus. Great news for those who signed the petition to WHO last summer, and even those who didn't. The World Health Organization’s (WHO) released on March 1, 2021 a Roadmap to improve and ensure good indoor ventilation in the context of COVID-19. This document provides practical advice on how to mitigate COVID-19 through airborne... Read more

Amal June Polt

Healthcare Design, one of the most respected and widely recognized trade journals in the health care AEC space has released the names of its 2022 HCD 10 winners.  The mission of The HCD 10 is to recognize and celebrate the broad spectrum of outstanding professionals in that industry and the influence they have on healthcare design.

One... Read more

Currently not for sale, being updated and re-released in November 2021.

New Guide to Thermal Insulation Report

The BuildingGreen Guide to Insulation provides detailed guidance on insulation products and practices, including cost comparisons and detailed recommendations on what insulation to use, and what to avoid. It's a treasure... Read more

CEUs are available for reading all the building-envelope product guides and primer. Click here to learn more and take the quiz.

Vapor retarders are meant to protect our building assemblies from getting wet, but they can also slow drying, contributing to mold and structural degradation.

BuildingGreen-Approved Vapor Retarders

We are looking at installing an aerobic biodigester in a commercial kitchen for an office client that is VERY concerned about zero waste.  Basically, this system takes food waste, treats it with micro-organisms to remove organic matter, and turns it into water of high enough quality to go straight to the sewer.  The manufacturer we are looking... Read more

Hello friends,

We are looking for recommendations for solar photovoltaic consultants to support one of our projects. We have used SEI in the past, but would like to develop a deeper bench and approach it from another angle. We aren’t too concerned about the consultant’s location, but are looking for someone that is on top of the current... Read more

Hello all,

I have a quick question for you. While Energy Star appliances are a no-brainer for projects, I don't see a hard requirement to select Energy Star appliances in the energy prereq/credit. There are references in the water section for water using appliances like ice machines, dishwashers, clothes washers, etc., but no related... Read more

Join Brent & Alex to learn what's new and what's been updated in our BuildingGreen Guide to Thermal Insulation, Fourth Edition, including what you should know about:

So much has changed so quickly!

Our 30-minute roundtable... Read more

Hello Everyone!

Wondering if anyone has expertise in Algae Photobioreactor facades? Here is a product: https://cellparc.com/

My basic understanding is that they produce heat and biogas (as well as providing shade and some thermal value.)  However, I am not clear on the GHG balance benefit, so to speak.  I cannot determine if the... Read more

Hi All,

I just became aware of the attached detail (if I uploaded it correctly) for a project in Portland, OR going out for permit at the end of this week.  Has anyone located the radiant tubing at the bottom of concrete like this before?  It doesn't sit right with me, though I cannot pinpoint exactly why.  Our consultants and the... Read more

Hi MEP Leaders,

I would not normally post a job on this forum, but Placetailor is seeking to hire a mechanical engineer.  They are one of only two truly sustainable developers that I've ever heard of.  They are an integrated developer / builder / design firm that builds everything they touch to Passive House and carbon neutral standards... Read more

Hi all,

We’re thrilled to share that registration is now open for our All-Networks Workshop on Integrated Design + Delivery from the Inside Out! The workshop will be held on July 15th at Miller Hull’s Seattle office, right before the Summer 2024 SDL Summit. Register now before it fills up, and please feel free to email me with any... Read more

Hi All,
We have a date and time for the next SCL Carbon Working Group Meeting, "see" you there:

Topic: SCL Carbon Working Group Mtg #2
Time: Mar 31, 2020 09:00 AM Pacific Time (US and Canada)

Join Zoom Meeting
https://sellen.zoom.us/j/595221970

Meeting ID: 595 221 970

Dial in info:
        +1... Read more