Championing the
Changemakers

Just saying "Hello"  and happy to be joining the SDL peer network.  I am leading the effort at Integrus Architecture (Seattle and Spokane) to integrate performance and design and am looking forward to learning how others are accomplishing the same. 

Hello Sustainable Design Leaders!

Here are the details for an upcoming SDL Peer Network web call, this webinar will be a call to share research and resources around mass timber. Hope to see you there!
REGISTER HERE!

Embodied Carbon and Mass Timber – a shared learning conversation
March 31st, 2020
3pm - 4pm ET (... Read more

Welcome to the quiz portion of In-House Daylight Modeling.

Learning Objectives
Upon completing this course, participants will be able to:


1. Explain general daylighting theory and design.
2. Simulate towards better daylighting design.
3. Demonstrate how daylight modeling is used in practice.
4.... Read more

Team,

Many of you saw this from BlackRock.

https://www.blackrock.com/corporate/investor-relations/larry-fink-ceo-letter

SOM, starting with London office, is drafting a letter to our MEP consultants, demanding and holding them accountable for climate change as a preference on consultants selection.

Best,
LL 

Hello Folks,
What is your experience with successes and failures in the design process? As a starting point I have listed my Top 5 for success, and my Top 5 for failure. We'd love to see your reactions and look forward to the discussion when we all meet next week at our monthly check-in.

Top 5 reasons for when integrative design... Read more

WELL & Fitwel and beyond.

Guiding Questions:

Hi all,

We have a newly constructed, core/shell project having some hot water issues in the core restrooms.

There is a 0.35 Toto lav installed throughout. The hot water heaters are adjacent on each floor, located in the janitor closets. We did the math, and there could be a gallon of water standing and cooling in the pipe between... Read more

Hi, folks! 

I was recently asked if BuildingGreen could connect prospective speakers to an event organizer in Chicago. Beyond the leaders in the BuildingGreen networks relayed, I wanted to share that the exercise led me to the Women and Climate speaker database: https://www.womenandclimate.co/speaker-database 

When filtering by... Read more

Hello all,

This month's SCDL call was full of great discussion! We decided this month that we are feeling good about where we are for the Task Force Agreement on defining social sustainabiltiy in our work. The aim is to work with this agreement for a while and see if it holds up as a process framework. There was also interest to invite... Read more

We have an MEP engineer that is calculating peak loads at about 6 times passive house levels on a large commercial building that is at or near passive house levels of insulation and air infiltration. We suspect one reason is that he is figuring a 50% efficiency level for the ERV. We are showing him ERV systems with 80-90% efficiency, but they... Read more

We had these conversations grouped by size of firm. 

Guiding Questions:

Knowledge Management By Firm Size

How to give people the info they need, when they need it?

Is the COTE Top Ten a good framework?

This seems extremely daunting in a large firm. How do we manage content that is produced and shared... Read more

D.J. Greenspecher

The page you're looking for is no longer available. There may be several reasons:

Hi SDLers! I hope early fall is finding you well.

There is a current opportunity to make a difference in the campaign to reduce use of toxic flame retardants.

Arlene Blum and the Green Science Policy Institute, whom many of you know, are currently organizing a campaign of support for the CA State Fire Marshal's proposal to allow... Read more

On a large sports project, we worked with the structural engineer to spec low carbon / high SCM concrete mixes. Much of the floor area will be sealed and polished concrete, and a concrete sub is pushing back on the SCMs saying they should not be above 20% (with a preference for 0%) for the polish to finish properly, per the manufacturer. Anyone... Read more

***Cross-posting this from SCL Group***

Last year I was approached by Green Advantage, remember them from like 2005? There has been a LEED innovation credit for as long as I can remember.

Has anyone seen employed Green Advantage recently? Is anyone asking for it?

Do you see value in GCs/CMs/trades having this training... Read more