Championing the
Changemakers

Hi all,

We know preparations for Greenbuild are well underway for many of you. We also know that there will be many things competing for your time while you're there. Here's one more to consider! We don't have all the details solidified yet, but wanted you to know sooner rather than later for planning purposes.

We hope you’ll... Read more

Here is a fundamental question regarding measuring operational carbon emissions that I'm sure many of you can clarify for me:  Let's say you are considering design options and you want to know the relative contribution of GWP of adding an additional inch of continuous insulation to the building envelope.  The GWP from embodied carbon will... Read more

Hello lovely Green Gurus. Hope you all are well. I am wondering if anyone has installed an indoor sports floor that performed well and is low-emitting. This is for a multi-purpose gymnasium at a community center. Any chance?  Thanks All!

Hello all, 

Wondering if anyone has experience with lead limits in electrical cable and wiring? 

LEED for Healthcare allows a limit of 300 ppm of lead in electrical wire and cabling - my search for compliant products has been all dead ends. (MRc PBT Source Reduction - lead, cadmium, and copper)

Acceptable regulations for... Read more

Ventilation fans, kitchen range hoods, and laboratory fume hoods can use significant amounts of energy from both the fan motor and from venting heated/cooled air out of the building—air that then has to be replaced and conditioned by energy-intensive HVAC systems.

BuildingGreen-Approved Ventilation Fans

BuildingGreen ventilation... Read more

D.J. Greenspecher

Hello all,

I need future weather files for a project. We are looking at three years, 2050, 2075, and 2095 using two climate change scenarios, low emissions, and high emissions. I have seen ARUP's Weathershift site that uses RCP 8.5 and RCP 4.5. Are we assuming that 2.6 is not achievable? I would have used this as a low emissions scenario... Read more

Overland Partners is looking for a Sustainable Design Analyst with 2+ years of experience working with teams to implement sustainability strategies and building performance simulation. 

More details here: https://www.overlandpartners.com/careers/sustainable-design-analyst/ Please pass along if you know of someone who may be a good fit... Read more

Hi friends,

We recently tracked our water consumption on site during the structural demolition of some existing reinforced concrete buildings.  The new OSHA silica regulations required us to keep dust to virtually zero, so we had a bunch of mist cannons and water hoses pumping water around the clock.  We consumed ~855,000 gallons in a... Read more

Hi All,

My team member is leaving Webcor, and unfortunately that means we have to fill her big shoes with someone new! I thought I'd reachout here and see if you know anyone of high caliber looking for a Sustainability Manager position? Someone with LEED PM experience preferred, and a bit more technical background with MEP/ZNE ideally... Read more

Is LEED Online mind-numbingly slow today for anyone else? Or is it just me? I may give up and try again tomorrow. Frustrating as I was hoping to submit a final review today. :(

Welcome to the quiz portion of Fundamentals of High-Performance Building Assemblies.

Learning Objectives
Upon completing this course, participants will be able to:


1. Recall how the acronym ENDURE speaks to the unifying aspect of high-performance buildings.
2. Describe how to apply the principles of high-... Read more

The Water Sub-Group met today. This group is working on three items: 

1. Project Water Plan Template

2. Project Water Tracking Form Template

3. Research and Resources Document

The Meeting minutes are attached. The next meeting is 5/19/20 @ 2:30 PM CST, via webex and teleconference.  Please contact me if you would... Read more

Hello there, 

I am working on a project with indoor plants and active green walls. I would like to design lights for growing plants and people at the same time (which seems to be a non-obvious problem). 
 

I was thinking of Philips, GE, Shneider Lighting, etc. Would you recommend someone I could talk to and eventually engage... Read more

Resilience Resource Database

The Defining and Measuring Resilient Outcomes Working Group has been developing a Resilience Resource Database as a repository for resources related to the topic of resilience in our built environment. 

This database and map are endeavoring to show resources for resilient design across the country to... Read more