Seems to be a trend! We're looking to fill a Sustainability Specialist position at Perkins Eastman: 

http://perkinseastman.hrmdirect.com/employment/job-opening.php?req=89745...

Please let me know if you have any potential candidates who might be a good fit! 

Hi Everyone,

Who has worked on a SITES certification and can share the approximate hours involved for administering and completing documentation? A relative sense of the effort compared to LEED would also be helpful, similar to the thread about WELL on this same subject. 

Appreciate any insight. Thanks! -Hilary

Green Gurus,

We'd love your feedback.

The MEP group is endeavoring to make progress on integrative design. It has been long accepted that integrative design is necessary to make real progress, but a lack of stellar results demonstrates that it is easier said than done.

What is your experience with successes and failures... Read more

Wood was the first material used in window frame and sash construction, and it remains popular for homes with its warm feel and relatively high energy efficiency.

BuildingGreen-Approved Windows

Wood windows must achieve an NFRC-certified unit U-factor of 0.22 or lower. Manufacturers also must demonstrate that their highest-... Read more

Hi all - passing on this request on behalf of Alan Scott. He is looking specifically for someone from the Gulf Coast region to round out the panel:

I am putting together a panel for a virtual session during Design Museum Week in April (Thursday, April 28). The description below outlines the conversation I am hoping to curate. I am... Read more

Welcome to the quiz portion of Occupant Engagement: Where Design Meets Performance.

Learning Objectives
Upon completing this course, participants will be able to:


1. Restate at least five methods being used to provide feedback to occupants so that they better understand how to interpret, and respond to, their... Read more

Hi SDL!

Our CM recently offered up the possibility of substituting Pozzotive into our structural and paving concrete mix (www.pozzotive.com) on a large public building. Apparently it is on a level with the cost of standard cement.
We are eager to reduce the project's embodied carbon, and this seems almost too good to be true.

Hey Sages, Just lobbing this over the transome - not sure if anyone else cares :) but this would be a great group to dig in if anyone IS interested.

 For the past few years, I've been working on melding two completely separate worlds - our world (with typical project delivery) and the world of Agile (not just software development process... Read more

So our last webinar effort flamed out with the overloaded internet, but we've regrouped and have the session scheduled for this Thursday 4/2 at 1:10.  We pre-recorded the webinar to make sure everything goes smoothly and I have to say that Mike is delivering some pretty fantastic content. It doesn't engage LCA tools, rather focusing on core... Read more

Cher Hiblthren

Hi friends, 

Before i forget, here is the checklist I mentioned yesterday that got such a positive response in our office - again it came about after i was asked (for the Nth time) to write a sustainability description for a concept proposal/ RFP that I was not a part of and frankly didn't have a lot going for it. So it's framed as "you... Read more

Welcome to the quiz portion of Downscaled Climate Data: Where to Get It and How to Use It.

Learning Objectives
Upon completing this course, participants will be able to:


1.  Define “downscaled climate data” and understand where to find it and how to apply it in modeling to achieve greater environmental sustainability and... Read more

Successfully managing the LEED documentation process requires specific knowledge, tools, and skills that are not covered in the LEED Reference Manual. This CEU course is based on the LEED Project Management course that GreenStep developed and teaches through UC–Berkeley Extension. It is designed for professionals who are somewhat familiar... Read more

Hi all,

I am working on a Div 01 sustainability spec section for our firm to include by default on all projects. I've been finding a lot of great sample language out there for embodied carbon measures and material transparency (huge thanks to anyone here who had a part in developing those resources). 

One thing I'd like to include... Read more

Wondering if we can have a dialog on HVAC load calculation software... we are currently still using Trane Trace 700, but with the future migration to Trace 3D+ coming are looking into other options. Never used HAP but I haven't heard great things, and we dabbled in IES VE for a while, but went back to Trace since at that time there was no... Read more

The deadline for submitting presentations is coming up. This year ASHRAE is hosting a joint conference with Simbuild. We are just about to send out an extension announcement (It is now Feb 9th) , so there is still time to get an abstract for a presentation. 

Possible ideas for topics: 

Daylight - new metrics and... Read more