Pipe that delivers domestic water in North America is typically made from copper, chlorinated polyvinyl chloride (CPVC), cross-linked polyethylene (PEX), all of which present environmental challenges. Bimodal polyethylene  (PE-RT) and polypropylene (PP) are potential alternatives with lower climate and health impacts.
... Read more

All,

Can anyone suggest a product for the following situation.  We are looking to insulate existing aluminum eterior column covers that have a three inch air gap.  The issue is there is no way to remove the covers without destroying them.  we would like to cut small holes, pump in the insulation  and then cap the holes.  Can anyone... Read more

Welcome to the quiz portion of Five Reasons to Be Optimistic About Solar Energy!

Learning Objectives
Upon completing this course, participants will be able to:


Describe three ways how PV decreases environmental impact while increasing sustainability and health measures for communities.

Discuss PV life-cycle... Read more

Hello - I seem to remember a thread on Sustainable Design Specialist / Advisor - Focused or Integrated Position within a firm. Does anyone remember the subject header or did I just dream this up? My searches are coming up empty...

Thanks!

Mona

Mona Lemoine, Architect AIBC, MAA, MRAIC, LFA, LEED AP BD + C

Senior... Read more

Hello all, there has been a fair amount of discussion about the emerging Cove Tool for early stage energy modelling and parametric optimization at our firm. I am very curious if any of you are using this software, and if so, what are your thoughts about it? 

https://www.covetool.com/

Thanks,

Esteban Matheus

We are coordinating an effort to produce a "Building Reuse Practice Guide for Climate Action" for the AIA.  This is intended as a resource for architects working on major renovations and adaptive reuse, with a focus on reducing energy use, lower embodied carbon, electrification, and adapting to a changing climate. We are looking for around 5... Read more

I'm looking for successful examples of net-zero, Living Building, or similar office buildings that are NOT owned by highly-motivated organizations like RMI or the Bullitt Foundation (or one of your firms).

We are looking to team with a developer on a small-mid-size office building that will house our new office with us as a tenant (no... Read more

To piggyback off Nathan's introduction where he mentions construction waste management, who is doing anything innovative or different in managing construction waste?  Construction waste has not historically been a passion of mine, but now working in sustainability and construction, I feel like it has to be by default.  

We have a... Read more

The site license permits the purchaser to share the PDF Study-Guide file within their company/organization and... Read more

All,

Some of my colleagues and I have been working to promote interest in mass timber construction for K-12 builidngs.  As part of that effort we redesigned a large high school using mass timber in lieu steel, and conducted a whole building life cycel assessment to measure the reduction in embodied carbon.  We also conducted a program-... Read more

Dear All!

Crowdsourcing here to see if anyone has access to two LCA's that can be used to compare functionally equivalent consumer products: a fossil fuel powered to a battery one?  (A good product might be a car or stove, or a heating system with a boiler compared to a heat pump, perhaps?  Needs to include the B-use phase probably...)... Read more

Hi folks -

I was contacted last week by the producer of the documentary that launches this Thursday, 12/10 - he is hoping to generate interest among folks across the environmental spectrum (which of course includes all of us!) so I am sharing his pitch below with you all. The subject of water scarcity and drought is only going to... Read more

Erika Heet is the Editor-in-Chief of BuildingGreen. She is the former Editor-in-Chief of Interiors magazine. She has held senior editor positions at Dwell and Architectural Digest, and is the author of two books on modern architecture. She has served on the boards of Greenbuild and the Sustainable Furnishings Council, as well as on juries for... Read more

We’ve reached the maximum capacity of our venue for the Show-and-Tell next Tuesday at Greenbuild in DC. We also have a full slate of great presentations lined up. Thank you, Perkins Eastman, for hosting!

RSVP is now closed—we're looking forward to a packed house and we won't be able to let folks in who are not on the list.

We can'... Read more

All,

I'm looking for a quick methodology to estimate GHG emissions from refrigerants on a per SF basis. Are there any benchmark studies or quick calculators similar to the embodied carbon study? https://carbonleadershipforum.org/embodied-carbon-benchmark-study-1/

Thanks,

Josh

Building materials emit massive amounts of carbon long before the lights go on.

In this course, BuildingGreen takes an analytical look at the greenhouse gases that are emitted in the process of constructing our buildings in the first place—the embodied carbon. The report focuses on how architects and designers, working with other key... Read more

Does anyone have experience with Oknoplast PAVA windows that they would be willing to share?

It’s Summer Summit season! One of the “good problem to have” challenges we’ve had at recent SDL Summits has been too many great five-minute presentations. It’s hard to find time for them all. This year, since we’ll be online anyway, we can get a jump on that by starting the five-minute presentations early. Plus, we can share them across all the... Read more