Happy Friday, SDL!

We're running a Tally WBLCA for an environmental education center, which has a very small floor area but a fairly robust concrete/steel structure. Still, I was surprised to find an intensity of over 1,000 kgCO2/m2 for the building.

This is way higher than the general benchmarks I've found in the CLF's database,... Read more

Please share this info with any contacts you have that you think would be a good candidate for our Design Performance Coordinator position -- Thanks!

Design Performance Coordinator in San Antonio

Hi all!

I'm working on my first energy positive / passive house multifamily building and trying to figure out the trash/recycling chute. I am curious what solutions you have employed to make the trash chute air tight? We have excluded the whole chute from the envelope. Do you use airtight doors (and which ones?) at each floor trash/... Read more

Welcome to the quiz portion of Existing Buildings Are Architecture’s Future!

Learning Objectives
Upon completing this course, participants will be able to:


Hi, we need 3-4 folks to volunteer to join us to work out a draft Materials section for the Contractors Commitment.  Meeting set for 6/16 @ 2 PM CST.

Please message me at pslloyd@leopardo.com if interested in participating.  I will forward out the meeting invite. If the time doesn't work, but you want to participate, I will share info in... Read more

Hi,

I have a colleague doing research on PCM in several projects. For context in their report, they were wondering if this group has seen any recent increase in application of PCMs in recent years. Is it just in ceilings or other applications? If so, what products are being used? They were having difficulty finding manufacturers other... Read more

Is anyone else working on a project doing Living Building Challenge v4.0 Energy Petal? We're working through the Imperative 08 Net Positive Carbon Resiliency Strategy requirements that ask for the project to be habitable for a week in the event of an emergency. We're curious how others are defining "habitable" and what systems assumptions... Read more

Welcome to the quiz portion of Getting Flame Retardants Out of Foam Insulation.

Learning Objectives
Upon completing this course, participants will be able to:


1. Summarize why and how flame retardants are used in foam insulation.
2. Elucidate the case for taking the chemicals out of foam insulation.
3.... Read more

Are any of you working on projects that are pursuing the additional point for Indoor Water Use Reduction on a HC project via Table 4 Compliant laboratory and medical equipment? If so, what sterilizers are the projects using?

We are receiving pushback that the Sterilizer metric doesn't make sense. I am interested in any insight or a... Read more

Hi All - as Environmental, Social and Governance (ESG) becomes increasingly prevalent, I'm trying to learn more about what types of requests for ESG-related information folks are actually receiving and what types of trainings on ESG would be most helpful.  Drilling down a bit, I'm curious as to how ESG data points are moving down the supply... Read more

Board insulation has good thermal performance ranging from about R-4 to R-8 and is used as an integral part of a building envelope’s continuous insulation system.

Because board insulation is used on the building exterior, it is not always subject to the same material health and emissions requirements as batt insulation used inside the... Read more

Poppy Gasbag

Are FSC glulams available? By many manufacturers? Which ones?

Hi everyone,

As you may know the ICC has changed the way the IECC will be written in the future and most of us think that will reduce the stringency of the future energy codes that are the biggest lever in the fight against climate change within the buildings sector.

So one of the best pathways forward is via ASHRAE, which has a... Read more

Is anyone aware of research or guidance that has looked at VOC’s from roofing products and ventilation intakes? I’ve done some searching, and focus is mainly on managing the construction process to reduce installer exposure. 

Thanks for any help!

Tate

Hi! I'm writing a short news piece on WELL v2 and looking for someone very familiar with the existing and v2 standards to interview about the changes. If you meet that description and would like to go on the record with your thoughts, please reply to me directly at paula@buildinggreen.com. Thanks!

Hello Gurus,

I’m writing to share with you an effort a small group of lighting designers from the Boston area started which is now rolling into a large scale effort.  We’ve put together a Lighting Advocacy Letter to accelerate the sustainability of lighting products. Inspired by the AIA Materials Pledge, the letter is intended to... Read more