At first glance,

An Environmental Handbook for Florida Contractors looks like it deals only with the environmental regulations that Florida contractors must contend with. And, indeed, the Handbook describes in detail the requirements for complying with regulations at the federal, state, and local levels. But the book goes much further,... Read more

Builders concerned about out-gassing of formaldehyde from medium-density fiberboard (MDF) have long used Medex in cabinets. This exterior-grade product, originally developed for highway signs, is considerably more expensive than conventional MDF or particleboard, however. Now Medite II fills the need for a... Read more

Protecting trees and the local ecosystem when building on previously unbuilt land is a vitally important—yet often overlooked—part of environmentally responsible construction. Healthy trees and shrubs can reduce a home’s environmental impact and directly benefit homeowners in a number of ways:

•Enhancing comfort by shielding the house... Read more

The American Institute of Architects convention in Boston this past June was the setting for a changing of the guard in the American architectural establishment. The Institute’s first woman president took the reins, the Committee on the Environment became its largest and fastest growing committee, and the first installments of the Environmental... Read more

Ozone depletion and global warming are two of our most serious environmental problems—and foam insulation materials containing CFCs (chlorofluorocarbons) contribute significantly to both of these problems. The environmentally concerned builder or designer should make it a highest priority to avoid them. Even many of the non-CFC alternatives... Read more

Buildings have a tremendous impact on the environment. In North America, buildings and the building industry account for about 30% of carbon dioxide emissions, 35-40% of ozone depletion, 20-30% of municipal solid waste, vast quantities of natural resource consumption, and dramatic loss of open space each... Read more

Q.Where would you say architects as a group stand on environmental issues?

A.Architects tend to be reactive rather than proactive. It is important that we take the lead on these environmental issues. The architecture schools in particular tend to be conservative. They just aren’t... Read more

Hi Fellow SDLers: I'm sure you're like me and thrilled at the news of the Senate's passage of the historic climate bill yesterday. And also are likely on pins and needles until it's passed the House and signed into law. What a conclusion of a terrible roller-coaster ride that is our Congressional system.

I'm writing to pass along a... Read more

Welcome to the quiz portion of The Four Core Issues to Tackle for Resilient Design (And the Programs That Can Help).

Learning Objectives
Upon completing this course, participants will be able to:


1. Use site-specific hazard analysis to evaluate a project’s resiliency demands.
2. Use climate change data to... Read more

Hi all!

A couple years ago now there was an incredible thread here about circadian lighting design and WELL. There was a lot of dipping toes in the water with intent to gather lessons learned and report back.

What have been the high points and low points of circadian lighting design so far? What seems cost-effective and worth... Read more

Has anyone been involved with GBC Italia's Historic Building protocol? They are requesting pilot projects and I'm wondering if anyone has experience using or developing this framework. 

See attached checklist and form. Their website is pretty challenging to use. But so is USGBC...

Thanks!

Is anyone aware of research or guidance that has looked at VOC’s from roofing products and ventilation intakes? I’ve done some searching, and focus is mainly on managing the construction process to reduce installer exposure. 

Thanks for any help!

Tate

is anyone aware of some guidance about citation protocols for when a person/team/org uses an AI tool to generate some base components for a report (which is then heavily edited by humans)?

I'm inclined to disclose in detail which tools were used and how ... but would love to know if there are some industry protocols shaping up about this... Read more

I am looking for example specifications for low carbon concrete to have our structural engineer(s) review and incorporate.  Does anyone have good examples or  link(s) to good examples?

Thanks,

Mark

Environmental, social, and governance (ESG) reporting is an increasingly common expectation throughout financial sectors, and the real estate industry is no exception. 

This live webinar with our friend Chris Pyke, Ph.D., a senior vice president... Read more

We considering PV glazing for a project in SW Louisiana. Anyone have any successful PV glazing projects? Is this ready for primetime? 

ASHRAE posted this year's list of honors and right there at the top of the list is our SMEPL colleague, Cindy Cogil - now able to add FASHRAE to her signature block!  Well done, Cindy and congratulations to ASHRAE for recognizing your accomplishments.