Welcome to the quiz portion of How To Run a Great Workshop: 37 Tips and Ideas.

Learning Objectives
Upon completing this course, participants will be able to:


1. Explain how the right mindset contributes to a successful design workshop.
2. Schedule a design workshop, set its agenda, and balance the skills of its... Read more

Hello,

We’re looking for Design Energy Code Equivalents for Chinese commercial energy codes. Do any of you have  any good sources? I’ve only found data comparing ASHRAE 90.1 2013 to the Chinese Code at that time. We understand the Chinese code require a 65-75% energy savings over the baseline but don’t have good information for defining... Read more

Hi All,

Has anyone dug into ASHRAE 2016 as part of the new v4.1 requirements or as codes start to adopt it? I recently presented on this and thought I should check my math to make sure I'm understanding and communicating this correctly.

My understanding is that there is a new reference baseline, that is essentially the ASHRAE 2004... Read more

Hey Peer Network! Curious, if we can crowd-source a solution here for the pervious pavers at our Omaha office (climate zone 5A). Apparently over the years we've tried to add different kinds of fill here (gravel) but it keeps... disappearing. Any recommendations with either a replacement product or fill item? 

Hi Everyone, 

Has anyone had success in finding organizations or programs that will recycle the hard hats? We are looking into options for recycling our expired hard hats that can no longer be used. Ideally, we would want to use a company with facilities across the country but we are open to any suggestions or ideas you all may have.... Read more

hi all! I'm almost at the finish line with this year's 2030 reporting...whew. I'm running into an issue that I wanted to throw out to this group, regarding the zero tool and national average baselines. Hoping some of y'all who manage your firm's 2030 data, or are just more familiar with CBECS and related data, have some insight / experience to... Read more

All,

I've probably spoken to a few of you over the phone, but I wanted to make sure all of you know that we are hosting a 4 part webinar series on our Tally LCA software, kicking off tomorrow 10/10. We just released the new of Tally version and ended up doing far more development work than initially anticipated, in no small part due to... Read more

Here's the Core Purpose for this group that came out of the Inaugural Summit.

We're off and running!

Hi Carbon Working Group,

It’s been a while since our last online meeting on 3/31 –- admittedly, a bit too long -- so I wanted to share some updates.  You might have seen Candice Pearson’s 5/13 post about the structure of the Contractor’s Commitment and how it’s evolving into a set of guidelines available not only to our SCL Group but to... Read more

Hi Everyone!  About ten days ago, Megan Zack posted a note announcing her new role as Chief Sustainability Officer at Wight & Company. (Yay!)  I'm so delighted that she will be stepping into this leadership role at Wight to shepard the firm in the next chapter of their journey in sustainability. 

I wanted to take a moment to say... Read more

On a large sports project, we worked with the structural engineer to spec low carbon / high SCM concrete mixes. Much of the floor area will be sealed and polished concrete, and a concrete sub is pushing back on the SCMs saying they should not be above 20% (with a preference for 0%) for the polish to finish properly, per the manufacturer. Anyone... Read more

Products recommended by BuildingGreen avoid potentially hazardous additives and binders and have high recycled content or offer superior energy performance.

Recommended cellulose insulations are derived from agricultural waste, offer superior moisture or air leakage performance, or impart lower indoor air quality concerns than other... Read more

Here are the links I mentioned at today's meeting:

Timeline:
https://docs.google.com/presentation/d/1RlN4t23uvBtxEzp4QuyqL-w5bqmE4P90...

BG Contacts and Responsibilities:
https://docs.google.com/document/d/1MWYuAEitjk7Zpc8KUNf1LwG3-5wK6sIlgwro...

BITuser Contacts and Responsibilities:
https://docs.google.... Read more

Has anyone completed an LCA for an engineering structures lab, particularly one that has a strong wall and strong floor?