Following the summer SDL summit - we formed a spinoff user group called "Carbon Sync" to discuss Life Cycle and Carbon Assessment tools like Tally and Athena.  We've had three successful calls with folks sharing a couple 5-minute presentations about various studies and explorations.  We have a mix of experience levels - but are collaborating... Read more

Hi folks -

I was contacted last week by the producer of the documentary that launches this Thursday, 12/10 - he is hoping to generate interest among folks across the environmental spectrum (which of course includes all of us!) so I am sharing his pitch below with you all. The subject of water scarcity and drought is only going to... Read more

Tomorrow is my last day at FXCollaborative before I head back to school. It has been such a gift to engage with you all over the past 10 years. Please stay in touch - my contact information is ilanajudah@gmail.com. I am headed out to UBC next week to do a deep dive into resilience and adaptation in urban environments.

FXCollaborative... Read more

The ReUse Map created through the Material Flows Working Group is live and got some great traction at Greenbuild (Thank you Nadav and Barbara!).

To keep the map relevant and updated, we'll be looking at how to fund the maintenance of the map, the best ways to get the word out and looking at writing a white paper. If you want to be part... Read more

Hello all,

Does anyone know of any Rebate Program for either induction cooking equipment or kitchen electrification (new or existing)? Looking for any local or state or even federal programs (outside of California) that incentivize designing/building/retrofitting towards an all electric kitchen for any program type (institutional, single... Read more

Caseworks can be made from unsustainable wood and other materials, and with adhesives and finishes that offgas formaldehyde and other hazardous compounds.

BuildingGreen-Approved Casework

Approved caseworks are:

Hello Folks,
What is your experience with successes and failures in the design process? As a starting point I have listed my Top 5 for success, and my Top 5 for failure. We'd love to see your reactions and look forward to the discussion when we all meet next week at our monthly check-in.

Top 5 reasons for when integrative design... Read more

Help regarding below...

OSHA, see below link, suggests 6' social distancing for unvaccinated or at-risk workers.

https://www.osha.gov/coronavirus/safework#role-employers-workers

Is your office going to maintain 6' social distancing for your workers?   Is the reason above because there are unvaccinated or at-risk workers?... Read more

Hi all, 

Following the SCL Summit back in November, the Waste Subgroup agreed to complete a Model Waste Management Plan to serve as a contractor commitment to reduce construction waste. I distributed the attached (very rough) draft back in Jan., and received some good feedback via forum comments. 

We would like to set up a call to... Read more

Currently not for sale, being updated and re-released in November 2021.

New Guide to Thermal Insulation Report

The BuildingGreen Guide to Insulation provides detailed guidance on insulation products and practices, including cost comparisons and detailed recommendations on what insulation to use, and what to avoid. It's a treasure... Read more

At the summit we discussed sharing which consultants our firms have used for anti-bias training and EDI education. My office will participate in the upcoming AIA Seattle pilot Intercultural Leadership Program, but that only includes two of our firm leaders. If anyone can refer a consultant in the Seattle region for all-office trainings, I'd... Read more

Hello - 

I am looking for the recording and the PDF/ slides that were shared 3/6 for the project process share-out/ 5 min presentations. It was super inspiring and I would like to refresh my memory of some of what was shared. Thank you!

–
Alison Nash 
AIA, LEED AP ID+C, CPHC, WELL AP
Associate | Sustainability... Read more

Welcome to the quiz portion of Five Reasons to Be Optimistic About Solar Energy!

Learning Objectives
Upon completing this course, participants will be able to:


Describe three ways how PV decreases environmental impact while increasing sustainability and health measures for communities.

Discuss PV life-cycle... Read more

After reviewing BP language today with internal staff, we realized we'll need to add a glossary to explain industry jargon and technical terms that might not be widely used. I'd like to consolidate those terms onto one web page, a glossary. This probably should be on the list with the best practices, and it will need its own page. Thanks!

Hi folks, 

AIA COTE National is looking for Techincal Reviewers for the 2025 awards. Interested, or know someone who might be?  Sign up here: https://form.jotform.com/231175886103153

Thanks!

Pipe that delivers domestic water in North America is typically made from copper, chlorinated polyvinyl chloride (CPVC), cross-linked polyethylene (PEX), all of which present environmental challenges. Bimodal polyethylene  (PE-RT) and polypropylene (PP) are potential alternatives with lower climate and health impacts.
... Read more

Kelly provides administrative support to BuildingGreen projects, including major contracts as well as event planning, and logistics coordination for BuildingGreen’s network of sustainable design leaders. Among her projects, Kelly coordinated a large tri-state regional economic development project focused on the green goods and services industry... Read more