Hi all,

Just like many of you, our firm is dedicated to increasing representation in the professions and through its relationship to the AIA Large Firm Round Table was able to access a National Organization of Minority Architects Fellow this summer. We’re loving our work with Himesh thus far, but it’s unclear whether we have the workload... Read more

Beginning this year, Miller Hull will not only continue to quantify the upfront embodied carbon of every project we finish through construction, but now purchase third-party certified carbon offsets equivalent to one-third of the project’s impact. Great design is no longer enough - we must take responsibility for our architectural impact in the... Read more

For a number of years a colleague and I have been teaching a course about sustainability and water in architecture at the University of Pennsylvania's architectural school (PennDesign).  This year we're hoping to bring a few new opinions to the table for at the same time as we broaden the discussion.  Because the class will be virtual again... Read more

We have a client thats going through a TI remodel in a building thats a LEED Core+Shell certified building. One of the questions we are trying to figure out is are there things we need to be doing to not imperil the building's certification. 

I think the answer is that the landlord had to write tenant guidelines at the time of... Read more

Welcome to the quiz portion of Building Electrification: A Vital Solution to Climate Change.

Learning Objectives
Upon completing this course, participants will be able to:


1.  Understand the relationship between building electrification and decarbonization to improve the efficiency and sustainability of buildings.

2... Read more

Are your firms discussing the health effects of silica dust on people working with engineered stone and the recent announcement of the upcoming ban in Australia, as of July 2024?

https://www.dezeen.com/2023/12/14/australia-bans-engineered-stone-silico...

According to the article, a recent report says that there is no safe level of... Read more

I received the following email from Naajia at Southface.  I'll be out of town until November 8, but I'll see if there's time for me to address at least the second part before I leave:

A question regarding the BIT-User Forum was brought to my attention by a participant. Apparently when you are posting a question and you pick your location... Read more

Hello SAL Members - after last month's call, and invitation to do some thinking around the direction of the group, a few of us connected and brainstormed questions that might help guide and refine our network. It would be great to have a conversation around everyone's needs and goals, so if you could please take 5 minutes to respond to these... Read more

Alerting building occupants about indoor air pollutants is important in many situations.

BuildingGreen-Approved IAQ Equipment

Products approved by BuildingGreen range from single-use test kits to monitoring systems installed throughout a building. Some test for gases such as radon, VOCs, or carbon monoxide, and some for mold and... Read more

Hello SD Leaders!

Two weeks ago a group of us gathered for the Winter 2020 Sustainable Design Leaders Summit. Those of us from BuildingGreen that were on site, greatly appreciated everyone's time and energy. It's always a pleasure to work along side you all!

Here is the summit report!

Reminder: We are giving a priority look... Read more

My colleague, Kira Gould, from the AIA National COTE communications committee, has a great question I am reposting here...

AIA National COTE: In the early 00s, COTE supported an initiative through which we created a Guide to the Green RFP and collected sample RFP language. That now dated guide is no longer findable in our resources and... Read more

Welcome to the quiz portion of Seal, Tape, Gasket: A Sticky Search for Better Materials.

Learning Objectives
Upon completing this course, participants will be able to:


1. Choose the best means of achieving barrier continuity for any given application.
2. Assess a joint sealant's service life and product... Read more

We are trying to figure out how we are going to meet the LEED Credit for Building Life Cycle Impact Reduction for the first time.

One approach we're trying out: We're taking the results of our Tally model and looking at potential reductions from low-carbon concrete. However, the problem I am encountering is that when I take some of our... Read more

What a great first day!

Here are the slides from the show and tell presentations last night at SOM's office; everyone who presented with slides has given approval to share them.