At first glance,

An Environmental Handbook for Florida Contractors looks like it deals only with the environmental regulations that Florida contractors must contend with. And, indeed, the Handbook describes in detail the requirements for complying with regulations at the federal, state, and local levels. But the book goes much further,... Read more

Buildings have a tremendous impact on the environment. In North America, buildings and the building industry account for about 30% of carbon dioxide emissions, 35-40% of ozone depletion, 20-30% of municipal solid waste, vast quantities of natural resource consumption, and dramatic loss of open space each... Read more

Protecting trees and the local ecosystem when building on previously unbuilt land is a vitally important—yet often overlooked—part of environmentally responsible construction. Healthy trees and shrubs can reduce a home’s environmental impact and directly benefit homeowners in a number of ways:

•Enhancing comfort by shielding the house... Read more

Ozone depletion and global warming are two of our most serious environmental problems—and foam insulation materials containing CFCs (chlorofluorocarbons) contribute significantly to both of these problems. The environmentally concerned builder or designer should make it a highest priority to avoid them. Even many of the non-CFC alternatives... Read more

Q.Where would you say architects as a group stand on environmental issues?

A.Architects tend to be reactive rather than proactive. It is important that we take the lead on these environmental issues. The architecture schools in particular tend to be conservative. They just aren’t... Read more

The American Institute of Architects convention in Boston this past June was the setting for a changing of the guard in the American architectural establishment. The Institute’s first woman president took the reins, the Committee on the Environment became its largest and fastest growing committee, and the first installments of the Environmental... Read more

We are attempting to use Tally on a couple projects and are wondering how others are using the tool in their design process. If any experienced users out there would be willing to have a brief phone conversation I would appreciate it. Thanks

Lighting can be inefficient and have poor quality, short lifespans, and toxic ingredients.

BuildingGreen-Approved Replacement Lamps and Lighting

BuildingGreen approves a variety of replacement lamps and lighting, including:

This would be a great place to share insights and reflections from the opening session. 

Hi All,

If you have 5 minutes, we would appreciate your input in the Google Spreadsheet (linked below).  If you only have 1 minute, feel free to reply to this forum post and list your the typical equipment vendors you spec on projects.  :)

We're asking each of you to enter your "Top 3" specified vendors for each of the products... Read more

Hi all,

AGC is the biggest umbrella organization for general contractors in the states. To date, there has been practically no interaction between the SCL and AGC. In my mind, the SCL group is the most knowledgeable group of dedicated sustainability professionals out there; so is there a way that we can partner with AGC to collaborate ... Read more

Folks, would love to hear what software you're for in-house daylighting/energy performance modeling at the SD/DD level. My IT folks have been pushing us to try out Autodesk's Insight again after a not so impressive pilot we did a few years ago. Has it gotten better? Was it us? What programs do you feel good about? Which ones really make you mad... Read more

Team,

See this paper regarding outside air vs. filtration.

https://www.sciencedirect.com/science/article/pii/S0360132313002515

MERV-13 is a good way to get most benefits without a huge cost.

Best,
Luke Leung

We are evaluating Dynamic Glass - and I have always been a bit timid to use. 

Any thoughts / experience on what we should be aware of?

Thanks!

Welcome to the quiz portion of Choosing Insulation: High-Performance Roof Assemblies and Retrofits – Unit 4.

Learning Objectives
Upon completing this course, participants will be able to:


1. Explain the industry trajectory of healthier alternatives to foam insulation.
2. Describe the nuances of insulation... Read more

Hello! i had in my notes that the group interested in jobsite wellness was going to schedule a call mid-January.  I don't remember who was leading the effort.  does anyone have a list of who is on what committee?

thanks!