Builders concerned about out-gassing of formaldehyde from medium-density fiberboard (MDF) have long used Medex in cabinets. This exterior-grade product, originally developed for highway signs, is considerably more expensive than conventional MDF or particleboard, however. Now Medite II fills the need for a... Read more

It isn’t just environmental zealots who are up in arms about the U.S. Forest Service’s policies on managing the nation’s timber resources. The Association of Forest Service Employees for Environmental Ethics has jumped into the fray—from the inside. Jeff DeBonis, the Association’s founder and executive director,... Read more

To the best of our knowledge, this product is now being marketed under the name Rauhsaser by Better Wall System of Kenora, ON.

At first glance,

An Environmental Handbook for Florida Contractors looks like it deals only with the environmental regulations that Florida contractors must contend with. And, indeed, the Handbook describes in detail the requirements for complying with regulations at the federal, state, and local levels. But the book goes much further,... Read more

The recent ruling to allow logging on several thousand acres of old-growth forest in western Oregon was portrayed in the national media as a blow to environmentalists, but the action may not prove so damaging in the end. While the ruling permits logging on 13 of the 44 sites that were under consideration by the so-... Read more

Energy Source™ Directory

Energy Source Directory arrived. Assembled and published by Iris Communications, this is the most complete and most useful guide to specialized products and materials used in energy-efficient construction that we've seen. The 500-page directory is... Read more

Protecting trees and the local ecosystem when building on previously unbuilt land is a vitally important—yet often overlooked—part of environmentally responsible construction. Healthy trees and shrubs can reduce a home’s environmental impact and directly benefit homeowners in a number of ways:

•Enhancing comfort by shielding the house... Read more

Buildings have a tremendous impact on the environment. In North America, buildings and the building industry account for about 30% of carbon dioxide emissions, 35-40% of ozone depletion, 20-30% of municipal solid waste, vast quantities of natural resource consumption, and dramatic loss of open space each... Read more

The American Institute of Architects convention in Boston this past June was the setting for a changing of the guard in the American architectural establishment. The Institute’s first woman president took the reins, the Committee on the Environment became its largest and fastest growing committee, and the first installments of the Environmental... Read more

Ozone depletion and global warming are two of our most serious environmental problems—and foam insulation materials containing CFCs (chlorofluorocarbons) contribute significantly to both of these problems. The environmentally concerned builder or designer should make it a highest priority to avoid them. Even many of the non-CFC alternatives... Read more

Q.Where would you say architects as a group stand on environmental issues?

A.Architects tend to be reactive rather than proactive. It is important that we take the lead on these environmental issues. The architecture schools in particular tend to be conservative. They just aren’t... Read more

Hi All,

My team member is leaving Webcor, and unfortunately that means we have to fill her big shoes with someone new! I thought I'd reachout here and see if you know anyone of high caliber looking for a Sustainability Manager position? Someone with LEED PM experience preferred, and a bit more technical background with MEP/ZNE ideally... Read more

Hi all,

Thanks again to those who presented at the AIA Show & Tell! Here are the slides for some of the fascinating presentations we saw. Please do not share the slides outside of the networks unless they are marked “PUBLIC.”

There may be more to come; if you presented but did not yet provide permission for your slides to be... Read more

Dear all,

For a specific existing building application, we are looking for a half inch insulating glazing unit, preferably with low-e coating. Based on my research, 5/8" seems to be doable (1/8" glass + 3/8" air gap + 1/8" glass) but I'm yet to find a viable 1/2" solution. Have you come across any on your projects? Thanks for your... Read more

Hi All,

Has anyone successfully adopted a Revit to ClimateStudio workflow with their new export tool? Right now we are using cove.tool because it works reasonably well with iterative Revit modeling, but are itching to try a more accurate and nuanced alternative.

Thanks for any and all experiences!
Misha

HGA is seeking a Sustainable Materials Specialist to join our team! 

The role involves working with project teams to educate, research, and support decision-making related to sustainable materials and, in connection with sustainability experts across the firm, developing resources and tools to elevate HGA’s materials baseline.

The... Read more