Hi gurus,

Do any of you have preferred portable devices for indoor air quality monitoring? I know it's hard to find apples to apples, but ideally temperature, CO2, VOC, PM2.5, PM5 would be on the list. Mid-level accuracy - better than consumer, not as $ as IAQ professional level. Thanks!

As we begin to look into Scope 3 emissions reduction strategies, it's important to understand ways to reduce tranportation emissions to project sites. Is anyone aware of best practices or programs for contractor carpooling to jobsites? I know many of my colleagues travel to work together in one vehicle because of parking limitations, however,... Read more

OSB subflooring typically contains formaldehyde, and wood may not be sustainably sourced.

BuildingGreen-Approved Subflooring

Products approved by BuildingGreen contain no added formaldehyde or are available with FSC-certified content.

Magnesium oxide panels, which are particularly insect and moisture resistant, are also... Read more

Now available on demand

As more and more architects, designers, contractors and owners demand transparency surrounding human health impacts in the built environment, manufacturers need short cuts and tools to meet the call of this demand.

This webinar is intended to educate manufacturers about the market demands for creating... Read more

Welcome to the quiz portion of A Guide to Selecting Sustainable Textiles.

Learning Objectives

Upon completing this course, participants will be able to:


A colleague just pointed out an article about M-Fire. Its a factory applied fire inhibitor for wood construction. It's GreenGuard Gold but I can't find any real information. Have any of you heard of this or have any idea what it actually is? https://www.bisnow.com/national/news/construction-development/this-new-tech-will-stop-fires-before-they... Read more

Has anyone used a commercial heat pump water heater for a large protect?  I have found a few manufacturers for this technology, but want to make sure this is a viable and cost approach to electrical eliminate gas on a path to all electric.

Checking in to see if any of you have had good job site success with plastic water bottle recycling. Due to the LBC recycling requirements, we have to source separate onsite, and we're trying to has a separate plastics bin. For the most part, water bottles is going to be on of our biggest contributors.

Hi all,

We know preparations for Greenbuild are well underway for many of you. We also know that there will be many things competing for your time while you're there. Here's one more to consider! We don't have all the details solidified yet, but wanted you to know sooner rather than later for planning purposes.

We hope you’ll... Read more

Happy Friday Everyone!

Hoping to add a bit of excitement to the end of your week: 

Here is the Sustainable Construction Leaders 2020 Summit Report.

Enjoy!

RoseAnn for Candace, Nadav, and the BuildingGreen team

Hello all,

I need future weather files for a project. We are looking at three years, 2050, 2075, and 2095 using two climate change scenarios, low emissions, and high emissions. I have seen ARUP's Weathershift site that uses RCP 8.5 and RCP 4.5. Are we assuming that 2.6 is not achievable? I would have used this as a low emissions scenario... Read more

Is LEED Online mind-numbingly slow today for anyone else? Or is it just me? I may give up and try again tomorrow. Frustrating as I was hoping to submit a final review today. :(

Hi all,

Thanks again to those who presented at the AIA Show & Tell! Here are the slides for some of the fascinating presentations we saw. Please do not share the slides outside of the networks unless they are marked “PUBLIC.”

There may be more to come; if you presented but did not yet provide permission for your slides to be... Read more

Looking for an example or case study for a building utilizing a radiant heating/cooling in climate zone 4a. General use type is office with some public assembly spaces, total of 85,000 sf.

As usual, everyone, especially mechanical engineer, is terrified by the thought of "condensation." So far, I read a DGWW case study, "Energy... Read more

Hi everyone - in doing a carbon footprint for our firm, does anyone know if buildings that we design as Architects considered scope 3 emissions, or are they beyond the boundary of emissions? LMN's buildings, despite best efforts, are cumulatively multiple orders of magnitude above our scope 1 and 2 emissions. We have never included these... Read more

Hi all,

I'm curious how various firms are approaching their own office projects, re green building certifications. I'm especially interested in medium-large firms that have multiple offices, but policies and processes from small firms may still be instructive.

Do you have a firm-wide policy or is it a case-by-case thing? Has... Read more