Hi all,

We know preparations for Greenbuild are well underway for many of you. We also know that there will be many things competing for your time while you're there. Here's one more to consider! We don't have all the details solidified yet, but wanted you to know sooner rather than later for planning purposes.

We hope you’ll... Read more

Hello! 

We have several projects that are either pending ILFI Zero Carbon certification or the owner is planning to purchase offsets to cover construction emissions. Thus far, I have not considered this in our corporate footprint reporting. However, we are including A5 emissions whenever feasible and multiplying that performance over the... Read more

Hi all,

I'm curious if anyone has insight as to the "New Federal Building Performance Standards" that were announced in May of 2021 and then referenced again when E.O. 14057 came out. The memorandum for heads of agencies that was sent out with E.O. 14057 said that the CEQ would issue these standards, but I can't find a commitment to when... Read more

Our Peer Networks offer a safe haven to you and other leaders where you can support one another and work together toward sustainable solutions that are intent on moving projects and the industry forward in the best possible ways.... Read more

Good daylighting intentions can end up increasing glare and solar heat gain.

BuidlingGreen-Approved Lightshelves

We look for lightshelves designed to reflect direct sunlight onto the ceiling, turning what could potentially be glare into diffuse, ambient daylight that penetrates deep into the interior of a building.

Energy... Read more

I'm looking to compile an outdoor weather station for a local project, and we'd like to add local outdoor CO2 information to our data. I usually work with Onset HOBO products, but they don't offer an outdoor CO2 sensor. Their weather stations can take data from any CO2 sensor with an analog output - does anyone have any suggestions?

Under a high carbon scenario, most of North America will be 2 degrees C hotter by 2050. Meantime, we're designing buildings that will still be around in 2050, to codes that don't yet factor in chronic risks associated with climate change. I want to explain these risks to my colleagues; I'm hoping some of our green gurus can help answer the... Read more

Hello all, 

Any Fitwel experts out there? I have a 30,000 sf boutique hotel + spa client who would like to certify under the Fitwel rating system but Fitwel folks are telling me that no scorecard is currently available to hotel clients (can't use mulit-tenant or resi, that a hotel scorecard is under development). Has anyone used Fitwel... Read more

Hello all, 

Wondering if anyone has experience with lead limits in electrical cable and wiring? 

LEED for Healthcare allows a limit of 300 ppm of lead in electrical wire and cabling - my search for compliant products has been all dead ends. (MRc PBT Source Reduction - lead, cadmium, and copper)

Acceptable regulations for... Read more

Resilience Resource Database

The Defining and Measuring Resilient Outcomes Working Group has been developing a Resilience Resource Database as a repository for resources related to the topic of resilience in our built environment. 

This database and map are endeavoring to show resources for resilient design across the country to... Read more

Hi All, I was initially reluctant to share this, but I've seen similar posts and I think it's in line with our mission and interests so I'll go ahead with it.

Tomorrow 12/9 at 1 PM EST I'm moderating a panel of industry leaders in public health (as it pertains to buildings), construction finance, and project development to review the... Read more

Hello lovely Green Gurus. Hope you all are well. I am wondering if anyone has installed an indoor sports floor that performed well and is low-emitting. This is for a multi-purpose gymnasium at a community center. Any chance?  Thanks All!

Welcome to the quiz portion of Protect Your Spec: 14 Strategies. 

Learning Objectives
Upon completing this course, participants will be able to:


Identify ways to ensure continuity between the environmentally preferable materials in a project specification, and the less-than-ideal materials that end up used in the final... Read more

Friends,

Through AIA work I have been working with Kim Shinn from TLC Engineering. Kim is involved on the ASHRAE 209 development and has been advocating that the AIA, ASHRAE and USGBC align around this standard. Personally I think this is a good idea as I expect that this standard could easily make it's way into regulations and contracts... Read more

Folks, it is with a heavy heart that I write this: Lance Hosey passed away unexpectedly on Friday. 

Many of you know him from the early days of the SDL group, or as an outsized presence at any of the many conferences where we overlap. He's been a list-maker, poll-taker and all around troublemaker in my life for over 20 years; I know I am... Read more