Championing the
Changemakers

Hello Green Gurus! 

We are planning a virtual Show & Tell and Happy Hour for Oct. 30th 7pm - 9pm ET (4pm - 6pm PT) with a Halloween theme, bring your best costumes! We will hold presentations (virtually of course!) for about the first 1 hour and 20 minutes and then will transition to some fun Happy Hour festivities, sharing, and... Read more

Hello all,

I am reaching out to this community as SMMA has a job opening for a Sustainable Design Analyst (like many of you recently posting job openings on this forum).

Here is the job posting link: https://smma.applytojob.com/apply/mah0aDkOJ0/Sustainable-Design-Analyst

Please note that this position will support... Read more

We are working on a large healthcare project in Minnesota.  We're setting sustainability goals a bit late - no certification, but targets with accountability.  I'm working to determine recycled steel content (for structural steel and rebar), and I've gotten a bit of push-back on recycled content based on being in the region of the Iron Range... Read more

Hello SCL peeps, 

Thank you to all the people who filled out our 2021 event survey. Your feedback did help us narrow down the options, but it was still inconclusive about whether there’s enough interest in doing an SCL-only Summit. 

To stay on schedule with our planning (and to make sure the event will pencil out financially), we... Read more

Evaporative coolers use far less electricity than conventional refrigerant-cycle air conditioners and they operate without the use of refrigerants, both features that make them attractive for green buildings. However, their suitability is limited to drier climates, and most products use significant quantities of water.

BuildingGreen... Read more

I've been hearing recommendations for bipolar ionization, as a way to filter airborne virus particles in HVAC systems while avoiding the energy penalty of increased ventilation. However, I've also heard that ionizing equipment is dangerous because it produces ozone.

Does anyone have any insight into the effectiveness and/or cautions... Read more

Folks, would love to hear what software you're for in-house daylighting/energy performance modeling at the SD/DD level. My IT folks have been pushing us to try out Autodesk's Insight again after a not so impressive pilot we did a few years ago. Has it gotten better? Was it us? What programs do you feel good about? Which ones really make you mad... Read more

Welcome to the quiz portion of Choosing Insulation: High-Performance Wall Assemblies – Unit 3.

Learning Objectives
Upon completing this course, participants will be able to:


1. Describe key environmental and performance factors for insulation materials.
2. Recount bottom-line insulation material... Read more

He just posted the following on the Building Performance Knowledge Community forum:

Does anyone have a recommendation for software that is easy to use and relatively inexpensive for doing energy performance analysis at the schematic design (or before) phase?  We are looking for a tool that gives good quantitative comparisons for... Read more

Dear All,

Greetings. On this Earth Day, I hope you're enjoying our planet's gifts and also giving your gift with reckless abandon.

As I take a short break to plan what I want to do next, this coming Friday, April 26, will be my last day at HKS. Maybe I will get a Hitchhiker's Guide to the Galaxy tattoo like Paula. 

I... Read more

Hi everyone, 

Thank you so much to the SDL members who attended the Summer 2023 Summit! We had an amazing time with you there. A big thanks as well to the attendees who shared 5-minute presentations during the summit.

Below are some of the slides for the presentations. Please note that we have permission from all of these... Read more

Hello Green Gurus,

Here is the information for August's Peer Networks Webinar, A more Mindful Future: mindful MATERIALs plans for Digital Transformation through the Common Materials Framework. We hope you will join us!

Register HERE

A more Mindful Future: mindful MATERIALs plans for Digital Transformation through the Common... Read more

You’ve probably heard that wood products are carbon neutral. You might also have heard that timber harvesting causes immense carbon emissions.

Which is it?

Could it be both?

Hi all,

I see that this was a hot topic for the Winter Retreat this past year, but I am wondering how your firms manage standard materials across your practice. two aspects - standard specification items, and also designer choice materials. 

1. Do you have a spec baseline with high performance materials that you start with for all... Read more