A colleague just pointed out an article about M-Fire. Its a factory applied fire inhibitor for wood construction. It's GreenGuard Gold but I can't find any real information. Have any of you heard of this or have any idea what it actually is? https://www.bisnow.com/national/news/construction-development/this-new-tech-will-stop-fires-before-they... Read more

We have all these resources out here in the ether but it’s so hard to pull them into one spot! I was asked, last minute to join a client call today to help convince both the client (affordable housing developer) and the mechanical engineers to "stick with" a commitment to 100% electric design that was publicly stated when the competition was... Read more

Hi everyone - in doing a carbon footprint for our firm, does anyone know if buildings that we design as Architects considered scope 3 emissions, or are they beyond the boundary of emissions? LMN's buildings, despite best efforts, are cumulatively multiple orders of magnitude above our scope 1 and 2 emissions. We have never included these... Read more

Has anyone used a commercial heat pump water heater for a large protect?  I have found a few manufacturers for this technology, but want to make sure this is a viable and cost approach to electrical eliminate gas on a path to all electric.

Hello all,

I need future weather files for a project. We are looking at three years, 2050, 2075, and 2095 using two climate change scenarios, low emissions, and high emissions. I have seen ARUP's Weathershift site that uses RCP 8.5 and RCP 4.5. Are we assuming that 2.6 is not achievable? I would have used this as a low emissions scenario... Read more

Hi all,

Thanks again to those who presented at the AIA Show & Tell! Here are the slides for some of the fascinating presentations we saw. Please do not share the slides outside of the networks unless they are marked “PUBLIC.”

There may be more to come; if you presented but did not yet provide permission for your slides to be... Read more

Hi all,

We are looking to study Passive House on a couple small multifamily projects. Our understanding is that WUFI Passive only integrates with SketchUp at this time. Our BIM manager has been trying to find an example of a firm that works in Revit and uses WUFI Passive, to point him in the right direction on workflow. I offered to ask... Read more

Hello Sustainable Construction Leaders,

It's come to our attention that although we shared the slides from last fall's all-network Show & Tell in Atlanta, we neglected to include the presentations from the SCL Summit itself. Since we believe in "better late than never," here they are!

As a reminder: we have permission from... Read more

testing

Hello Green Gurus,

A close colleague of ours, Frances Yang of Arup, is distributing a survey developed in partnership with the Healthy Building Network (HBN).

The survey asks for which product categories you need more health information. Answers will help inform which product categories HBN next incorporates into its HomeFree and... Read more

Ventilation fans, kitchen range hoods, and laboratory fume hoods can use significant amounts of energy from both the fan motor and from venting heated/cooled air out of the building—air that then has to be replaced and conditioned by energy-intensive HVAC systems.

BuildingGreen-Approved Ventilation Fans

BuildingGreen ventilation... Read more

Hello all, 

Wondering if anyone has experience with lead limits in electrical cable and wiring? 

LEED for Healthcare allows a limit of 300 ppm of lead in electrical wire and cabling - my search for compliant products has been all dead ends. (MRc PBT Source Reduction - lead, cadmium, and copper)

Acceptable regulations for... Read more

Friends,

Through AIA work I have been working with Kim Shinn from TLC Engineering. Kim is involved on the ASHRAE 209 development and has been advocating that the AIA, ASHRAE and USGBC align around this standard. Personally I think this is a good idea as I expect that this standard could easily make it's way into regulations and contracts... Read more

Welcome to the quiz portion of Getting Flame Retardants Out of Foam Insulation.

Learning Objectives
Upon completing this course, participants will be able to:


1. Summarize why and how flame retardants are used in foam insulation.
2. Elucidate the case for taking the chemicals out of foam insulation.
3.... Read more

Under a high carbon scenario, most of North America will be 2 degrees C hotter by 2050. Meantime, we're designing buildings that will still be around in 2050, to codes that don't yet factor in chronic risks associated with climate change. I want to explain these risks to my colleagues; I'm hoping some of our green gurus can help answer the... Read more